Solubility equilibrium

Abstract In this study, a CO2-respensive GM-AD-HA hydrogel derived from electrostatics crosslinks and supramolecular bond will be produced and studied about its mechanical properties and physiological performance. It is expected to have application in restoring cartilage and controllable delivery of Epirubicin Background of research Hydrogels have crosslinked microstructure and can swell up in water without resolving. Their soft and rubbery nature minimizes inflammatory reactions of the…

Synthesis of PEG-RAFT agent The synthesis of the macro PEG -RAFT agent, Chain Transfer Agent (CTA), was performed by esterification method. Briefly, RAFT agent (0.4 g, 1.5 mmol) and dihydroxyl PEG (2g, 0.5 mmol) were dissolved in 35 mL of DCM in a 250 mL round bottom flask equipped with a magnetic stirrer. Then, it was placed in an ice bath (0 ºC); Next, DCC (0.25 g, 1.2 mmol) and DMAP (0.015 g, 0.12 mmol) were added. After 30 min of stirring at 0 °C, the reaction temperature is elevated to room…

A simple, economic, selective, precise, accurate and sensitive HPTLC method for analysis of Cilnidipine and Chlorthalidone, as a bulk drug and in formulation, was developed and validated according to ICH guidelines. The method employed HPTLC aluminium plates precoated with silica gel 60F-254 as the stationary phase while the solvent consisted of Toluene: Methanol: Ethyl acetate (8:2:0.1 v/v/v). The system was found to give compact spot for drug (Rf value of Cilnidipine and Chlorthalidone was…

Adsorption is the bond of particles, particles, or atoms from a gas, fluid, broken down and attached strongly to a surface. This procedure makes a film of the adsorbate on the surface of the adsorbent. This methodology varies from absorbtion, in which a liquid (the absorbate) pervades or is absorbed by a porous solid. Adsorption is a surface-based procedure while absorption includes the entire volume of the material. The term sorption envelops both methodologies, while desorption is the converse…

“Discussion of Results The goals of this experiment were approached in many ways. To figure out the solubility, which is the ability of a solid dissolving in a liquid, of oils, fats, and detergents, the group tried to dissolve all the beginning substances and finished products in a multitude of solvents. In the testing of the four starting substances for the soaps, the group found that all the substances were insoluble in water and hydrochloric acid. However, vegetable oil was soluble in…

Experiment 1 Name: Sanzhar Kerimbek 20140930 General Chemistry Laboratory 1 Fall Semester 2014 Co-worker: Byungsoo Kim 20140831 Date: 27.09.2014 Title:Volumetric analysis Introduction The concept of volumetric analysis is a part of chemical analysis and is performed foremost with the volumetric chemical glassware (i.e. Erlenmeyer flasks, burets, pipets, test tubes etc.). The aim is to find out the concentration of one substance by reacting it in aqueous solution with the substance with…

your data) Solubility - Fat was soluble in oil. Soap was not soluble in oil. Fat was not soluble in water. Soap was soluble in water. Reasoning (why does the above piece of evidence support your claim?) The above piece of evidence supports my claim because it proves that in the same substance (H2O), fat and soap have different solubility. In fact, they are opposites in solubility - the fat being insoluble and and soap being soluble. According to Scientific Principle #6, “Solubility is…

by investigating its solubility in water, hexane and ethyl alcohol. Also, its density and boiling point were obtained and compared to the theoretical values. Theory Chemical substances can be identified through investigation of their chemical and physical properties and then comparing the experimental values to the standard values. Physical properties do not change the chemical composition of the substance. Physical properties include; density, boiling point, and solubility, etc. The density…

As stated originally, our hypothesis for the laboratory experiment was that there is an inverse relationship between the percent abundance of tap water in a mixture and the size (diameter) (cm) of the bubbles produced from the respective mixture. However, our experimental process yielded just the opposite results- a direct relationship between the percent abundance of tap water in a mixture and the size (diameter) (cm) of the bubbles produced from the respective mixture- meaning that when there…

Mitchell Morgan CEM-161-007 Josh Ward 28th October 2015 Abstract The chief objective of this experiment was to identify the unknown compound. The following tests were conducted to eventually establish the identity of the compounded: qualitative solubility tests, anion and cation tests, flame test, and the formation of a precipitate. The physical properties of the unknown ionic compound found that it has no smell and was soluble in water. No ammonia smell was formed when conducting the…