Acetic anhydride

    Page 8 of 27 - About 267 Essays
  • Differences Between Acids And Bases

    1:1 ratio, the moles of CH3COOH is also identified (mol CH3COOH = mol NaOH). Using the molar mass of CH3COOH, the mass of acetic acid can be calculated, and compared to the mass of the overall vinegar solution (Thorne 86-87). These values can be compared to the theoretical values which state that the equilibrium constant of acetic acid is 1.8 x 10-5, and the percent mass of acetic acid in vinegar is 5%. Calculations/Discussion: Recorded data: Concentration of standardized NaOH Solution:…

    Words: 901 - Pages: 4
  • Acetonitrile Case Study

    3. EXPERIMENTAL WORK 3.1 Materials andMethods 3.1.1 Chemicalsand standards used Table.No.15 List of chemicalsand standards used S.No. Chemicals Manufacturer Name Grade 1 Water Merck HPLC grade 2 Acetonitrile Merck HPLC grade 3 0. 22µ Nylon filter Advanced lab HPLC grade 4 0.45µ filter paper Millipore HPLC grade 5 Theo asthalin Cipla syrup form 6 Salbutamol sulphate and theophylline In - House In- House 3.1.2 Instruments used Table.No.16. List of instruments used S.No Instrument name Model…

    Words: 3192 - Pages: 13
  • Case Study: Isolation And Proliferation Of MSC

    concentration of 0.075%) was added and incubated for 1h. The supernatant was discarded and the cells in 96-well plates were washed with PBS twice to remove the neutral red that was not phagocytized by macrophages. Then cell lysate (ethanol and 0/01 % acetic acid at the ratio of 1∶1, 200 µl/well) was added to lyse cells. After cells were incubated at 4℃ overnight, the optical density at 490 nm was measured by a microplate reader. 2.6. Phagocytosis Assay by opsonized heat-killed baker's…

    Words: 796 - Pages: 4
  • Thermometric Titration Lab Report

    Sharmistha Santra A Thermometric Titration Table: (Representing the results obtained from the experiment) Known Acid HCl 1 mol dm-3 (± 0.100) Unknown Acid HCl 0.76 mol dm-3 (± 0.100) Highest Temperature (Time) 28.5 (190s) 28.6 (235s) Lowest Temperature (Time) 22.9 (55s) 22.9 (55s) Sample Calculation for the Unknown Concentration C1V1 = C2V2 1 (190 - 505) = C2 (235 - 505) 1 28.0 = C2 37.0 C2 = 2837 C2 = 0.760 mol dm-3 (±0.0500) Sample Calculation for the amount of mole in Unknown…

    Words: 1009 - Pages: 5
  • Reeox Titration Lab Report

    Measuring the mass of Iron in an iron sulphate tablet using REDOX titration Aim The aim of this experiment is to determine the mass of iron present in one iron sulphate tablet using REDOX titration under acidic conditions. Safety H2SO4: This is an irritant which may cause burns on skin and eyes; therefore care must be taken when handling this chemical. Protective gear (gloves, lab coat and safety goggles) must be worn at all times. If it comes in contact with skin or eyes, it should be…

    Words: 1077 - Pages: 5
  • Difference Between Separation Of Aspirin And Naphthalene

    EXTRACTION OF A KNOWN MIXTURE Separation of mixture of Acetyl salicylic acid (aspirin) and naphthalene Experiment # 6 Introduction A technique called extraction will be demonstrated in this experiment. Extraction relies on the solubility of substances into solvents and the insolubility of the solvents into each other. In this experiment, three organic compounds (aspirin and naphthalene) will be separated from each other. The two compounds are all soluble in ethyl ether (an organic solvent). By…

    Words: 816 - Pages: 4
  • Acetonitrile Lab Report

    2.4 IL-DLLME procedures For IL-DLLME under optimum conditions, 10 mL of the sample solution containing Cd2+ or Ni2+ and PAN (10−5mol L−1) was adjusted to pH in a glass test tube with a conical bottom test tube. Using a microsyringe, the mixture of the extraction solvent ([Hmim][PF6]) and disperser solvent (acetonitrile) was rapidly injected into the previously mentioned aqueous sample. A cloudy solution (water, acetonitrile and [Hmim][PF6] ) was formed in the test tube. The ions reacted with…

    Words: 1600 - Pages: 7
  • Lab Experiment: The Purpose Of Banana Oil

    Khadra Hassan TA: Hannah Degraaf September 28th 2016 Banana Oil (lab report) Purpose: The purpose of this laboratory experiment was to synthesize banana oil (Isopentyl acetate) from the reaction of Acetic acid and Isopentyl alcohol by the Fischer Esterification reaction. By using the methods of refluxing, washing, drying, and simple distillation to purify the end product. When the product was isolated an IR, H NMR and boiling point were used analysis the product, the end product had a…

    Words: 1119 - Pages: 5
  • Lipid Extraction Essay

    The major bottleneck for lipid extraction from the wet microalgae is the low extraction efficiency, because of the immiscibility of nonpolar organic solvents with water contained in wet microalgae {Yoo, 2012 #31} {Kim, 2013 #118}. Traditional method for lipid extraction from dry biomass uses a co-solvent system, which consist of a non-polar solvent and polar solvent {Halim, 2012 #7} {Kim, 2013 #118}. When the co-solvent system is directly applied to wet microalgal biomass, the microalgal cells…

    Words: 1101 - Pages: 4
  • Urea Synthesis Lab Report

    The main principle of manufacture of urea has two main reactions. 2NH3 + CO2 NH2COONH4 -37.4 Kcal/mol NH2COONH4 NH2CONH2 + H2O + 6.3 Kcal/mol While going main reactions, the undesirable side reaction taking place is 2NH2CONH2 NH2CONHCONH2 (Biuret) + NH3 This process is further complicated by the formation of a substance called biuret, NH2CONHCONH2, which should be kept low because it adversely affects the growth…

    Words: 988 - Pages: 4
  • Page 1 5 6 7 8 9 10 11 12 27

Related Topics:

Popular Topics: