Weak base

    Page 5 of 50 - About 500 Essays
  • 1what Is An Acid-Base Titration?

    INTRODUCTION 1.1What is an acid-base titration? An acid –base titration is the determination of the concentration of an acid or base by neutralizing the acid or base with an acid or base of known concentration. An acid-base titration is the analysis of the concentration of acids and bases; through this process an acid or base of known concentration neutralizes an acid or base of unknown concentration. The neutralization of an acid or base in acid-base titration can be measured with either a…

    Words: 1357 - Pages: 6
  • Hydrotreate Vs CAT-E Analysis

    Fig 4.12 shows the comparison of product density of hydrotreated GO obtained using CAT-E and CAT-C. The density of hydrotreated GO from CAT-C at 370◦C was 0.8148g/ml whereas at the same temperature the density of hydrotreated GO obtained from CAT-E was 0.8302 g/ml despite sulphur and nitrogen in the GO has been reduced to less than 50 ppm and 1 ppm respectively. The reason for higher density would be due to higher aromatic content in the hydrotreated product obtained from CAT-E. This indicates…

    Words: 809 - Pages: 4
  • The Effect Of Organic Solvents On Particle Size

    Effect of Organic Solvents on Particle Size When anti solvent was 0.4% (w/v) F68 aqueous solution, the effect of various good solvent was investigated. These organic solvents include ethanol, methanol, PEG 400, propylene glycol. The result as mention in Table 16 & Figure 27 showed that the particles prepared by methanol were the smallest (317 nm) among other organic solvents. Ethanol, PEG 400, and propylene glycol produced the particles having the mean particle size of 525nm, 1274nm, 864nm,…

    Words: 1712 - Pages: 7
  • Soap Bar Lab Report

    4.0 INTRODUCTION TO RESULT AND DISCUSSION This chapter covers the result and also the discussion on the experiment of lab scale soap production. All of the findings which are the analysis of pH value, saponification value and moisture content of the formulation soap bar is discussed thoroughly throughout the chapter. 4.1 RESULT AND DISCUSSION The purposes of the experiment were to identify the weights of materials to be used in the formulation of soap and also to produce the average quality…

    Words: 1590 - Pages: 7
  • Molar Concentration Of Sodium Hydroxide Solution

    Abstract: The purpose of this experiment was to prepare and standardize a sodium hydroxide solution as well as determine the molar concentration in as strong acid and the percent by mass of acetic acid in vinegar. We used volumetric analysis, also known as titration, in both experiments. The average molar concentration for NaOH was 0.2749 mol/L while the average molar concentration of the acid solution was .2493 mol/L.The average percent by mass of acetic acid in vinegar was found to be 12.3 %…

    Words: 1494 - Pages: 6
  • Analysis Of C. Zigbee For Water Quality Monitoring

    One of the parameters that determines water quality is pH. It is defined as the negative logarithm of the hydrogen ion and is intended to be a measurement of the balance of acids and bases. Temperature affects pH. In pure water, a decrease in pH of 0.45 occurs when temperature is increased by 25°C [11]. There are several methods for measuring pH. The most common is the use of a glass electrode sensible to it, a reference electrode and a measurement device. Another method is the use of…

    Words: 721 - Pages: 3
  • Analysis Of Alka Seltzer

    Introduction: Alka-Seltzer is a medication used to alleviate ailments such as heartburn and acid indigestion1. The ingredients that the tablet is made up of helps explain the name of the medication, the sodium bicarbonate is used to balance stomach acid, help spread the aspirin which allows the speed of absorption to increase, and reacts with citric sodium which produces carbon dioxide2. One initial observation of the Alka-Seltzer tablet and water is that when the tablet was dropped into the…

    Words: 1720 - Pages: 7
  • Comparative Analysis Of Hormone And Hydrazone Carbamate

    The % relative standard deviation (% RSD) was found to be below 5 % for all the four analytes in system precision and below 6 % in method precision. The data as shown in Table 3.4.3.3.3 and 3.4.3.3.4. LOD values observed for Hydrazine carbamate and Hydrazone carbamate were 0.0018 µg per mL and 0.00092 µg per mL respectively. The LOD value observed for both 1-Hydroxy benzotriazole and 2R, 3S Chlorohydrine hydrochloride were 0.0019 µg per mL. The LOQ values observed for all four analytes were…

    Words: 952 - Pages: 4
  • Volumetric Analysis Lab

    The purpose and objective of this experiment was to determine the percent by mass of acetic acid within a sample of vinegar using volumetric analysis with the titration technique. The theory is that if the volume and molar concentration of the standardized sodium hydroxide (NaOH) solution is known, then the percent by mass of the acetic acid (CH3COOH) in vinegar can be calculated after a titration.1 Within this experiment, a NaOH solution was standardized with a primary standard acid of…

    Words: 731 - Pages: 3
  • Analysis Of Tris Hcl, L-Ascorbic Acid

    TRIS Hcl, NBT, NADH, Ethanol, PMS, l-ascorbic acid 1. The superoxide radicals is generated in 3 ml of TrisHCl buffer (16 mM, pH 8.0) containing 1 ml of NBT (50 μM), 1 ml NADH (78 μM) and ethanol extract of sample (25 – 50 μg). 2. The reaction was started by adding 1 ml of PMS solution (10 μM) to the mixture. 3. The reaction mixture was incubated at 25° C for 5 min, the absorbance was read at 560 nm using a spectrophotometer (Schimadzu UV-Vis 1700) against blank samples using l- ascorbic acid…

    Words: 738 - Pages: 3
  • Page 1 2 3 4 5 6 7 8 9 50

Related Topics:

Popular Topics: