Gastric acid

concentrations 0.1M, 0.2M, 0.3M, 0.4M). // Hydrochloric acid (2M). // 100cm3 conical flask. // 10cm3 measuring cylinder. // Dropping pipette. // Small piece of plain paper with a large X drawn with think black pen. // Stopwatch. // Goggles. Variables: Independent - The concentration of sodium thiosulfate solution (0.1M, 0.2M, 0.3M, 0.4M). Dependent - The time taken for the cross to not be seen. Control - // Concentration and volume hydrochloric acid/ volume of sodium thiosulfate solution - to…

solution, because it is the source of the Grignard reagent. Because the halide cannot be eliminated, the next best option is to minimize the amount of halide in the reaction. In this experiment, a small concentration of the halide is reacted with a high concentration of magnesium to ensure maximum contact between halides and magnesium. To do this, magnesium will be placed in the round bottom flask and then halides are slowly added. Another potential source of error is that Grignard reagents must…

Experiments involving chemical reactions can be performed using simple household ingredients and products such as baking soda and vinegar. When baking soda (sodium hydrogen carbonate) reacts with ethanoic acid which is found in vinegar in a 1:1 ration, the reaction will produce three different products which are water, carbon dioxide and Sodium acetate. The reaction is: NaHCO3 + HC2H3O2 → NaC2H3O2 + H2O + CO2 In the experiment, the quantitative relationship between the two reagents which is the…

Ethyl vinyl ether was used to protect –OH on glycidol based on a literature reported protocal.59 In a typical procedure, 0.675 mol glycidol and 200 mL ethyl vinyl ether were loaded in a round-bottom flask, to which 1.25 g TsOH was then added. The reaction was allowed to proceed at room temperature (RT) for 3h. The resulting mixture was then purified by washing with 100 ml saturated aqueous solution of NaHCO3 for 3 times. The organic layer obtained was dried by MgSO4. After filtration of MgSO4,…

CaBr2 is an ionic compound, because the second element is a non-metal so it will form an ionic compound. The next step in naming an ionic compound, is to name each component as if they were ions. The first component is a cation so you leave the name alone. The second component is an anion, so you change the ending of bromine to "-ide" and it’s becomes bromide. The last step is to combine the names so, CaBr2 becomes Calcium bromide. The first element of the formula NBr₃ is nitrogen a nonmetal,…

The objective of the lab was to determine the densities of known and unknown metal solids and liquids. For the liquids, initially, an Electronic Scale was placed onto Work Bench, and it was zeroed. An empty 50 mL Graduated Cylinder was placed onto the scale, weighing 54.00 grams. In increments of 10 mL. Until the volume was 30.00 Ml, 10.00 mL of water was poured into the Graduated Cylinder. In between each increase of 10.00 mL, the total volume and mass were recorded. For the known metals, the…

place. The temperature dropped about 6 degrees Celsius. The remaining solution was a filmy and diluted. The result was sodium acetate dissolved in water. This reaction was a double displacement reaction. The sodium bicarbonate reacted with the acetic acid vinegar and produced sodium acetate, water, and carbon dioxide. The carbon dioxide escaped from the solution leaving water and sodium acetate.…

Danika Ng CHEM 1252 L Exp 12: Thermodynamic Analysis of Chemical Equilibria INTRODUCTION The reaction being done with borax and HCl is an acid base reaction. The K constant expression of the reaction is Kc = [Na^+][B4O7^-2]. A titration is needed for this experiment because when a strong acid with a known concentration is added to a weak base, the unknown concentration of the weak base can be found, which can then find the moles of the weak base, which can then find the Kc. The first law of…

CHAPTER 1 INTRODUCTION 1.1. Introduction Caprolactam (CPL) is an organic compound with the formula (CH2)5C(O)NH. This colourless solid is a lactam or a cyclic amide of caproic acid. Caprolactam was first described in the late 1800s by Gabriel and Mass, when it was prepared by the cyclization of ε-aminocaproic acid, the product of the hydrolysis of caprolactam. In the months after Schlack’s discovery the first stocking were produced from Perlon. All the Perlon produced went to the war effort.…

reaction with vinegar? Aim: To find out how different amounts of baking soda (soda bicarbonate) affect the length of its chemical reaction with vinegar (acetic acid). Hypothesis: If the amount of baking soda is increased then the length of its reaction with vinegar will increase because there will be more soda bicarbonate for the acetic acid to react with. Equipment:  Baking Soda  Vinegar  5 glasses  Safety glasses  Measuring Spoons  Stopwatch  Scale Variables: -Independent variable:…