Breathing gas

Decent Essays
Improved Essays
Superior Essays
Great Essays
Brilliant Essays
    Page 7 of 50 - About 500 Essays
  • Great Essays

    fixed mass of gas held at a constant volume, which pressure divided by temperature is a constant value. The gas has initial pressure and final pressure of Pi and Pf respectively, and initial temperature and final temperature of Ti and Tf respectively. Therefore, the equation below is obtained: Pi/Ti=Pf/Tf Where, Pi = Initial pressure Pf = Final pressure Ti = Initial…

    • 1745 Words
    • 7 Pages
    Great Essays
  • Great Essays

    Simple Distillation Essay

    • 1587 Words
    • 7 Pages

    separating liquids with 2 different boiling points. Distillating requires heating and cooling of liquid components to eventually purify the mixtures. In distillation, heat is added to vaporize the liquid with the lower boiling point and this vapor gas bubble is condensed back into its liquid form, where it is then collected in a receiving flask or a graduated cylinder. Multiple distillations and collections, depending on the types of distillation techniques, yields distinct, separated liquids.…

    • 1587 Words
    • 7 Pages
    Great Essays
  • Improved Essays

    shown in the figure below, compressibility increases linearly as pressure decreases from 2500psi to the bubble point. At the bubble point, as pressure decreases now the compressibility increases exponentially. The change in gradient occurs as there is gas present in the fluid. Fig XX.…

    • 867 Words
    • 4 Pages
    Improved Essays
  • Great Essays

    states that a substance can exist as. A gas does not maintain shape and volume. Gases expand to fit and fill the container. While a liquid maintains volume, but not shape and fits the shape of the container it is placed in. Solids can maintain both volume and shape. When a gas exerts force on the walls of a container, this is known as its pressure. Pressure varies based on temperature and volume. Many gas laws were used within this experiment, such as the Ideal Gas Law, Boyle’s Law, Charles’s…

    • 1683 Words
    • 7 Pages
    Great Essays
  • Great Essays

    Essay On Water Rocket

    • 1530 Words
    • 7 Pages

    Introduction and Overview: For this extended essay, I will be working on building and optimizing different sized water rockets to find out the optimum amount of fuel (water) for each the different rocket sizes. I will be measuring the ranges at which each rocket will fly to find out the optimum fuel level. A brief summary of water rockets: A water rocket is made up of a selection of parts to provide its successful launch: the nose cone which will make the rather snub-nosed end of the large…

    • 1530 Words
    • 7 Pages
    Great Essays
  • Improved Essays

    Cyclohexene Lab Report

    • 946 Words
    • 4 Pages

    Cyclohexene distillation A fraction containing primarily cyclohexene primarily cyclohexene and water is separated from raw cyclohexanone in Cyclohexene column. Raw Cyclohexanone is fed from storage tank to Cyclohexene Column via Cyclohexene heater. In Cyclohexene Heater, the feed is heated up to about 1200C with the heat carried by the bottom product from Alcohols column. The Cyclohexene column is operated at atmospheric pressure and temperatures of 850C at top and 1650C at bottom. The vapours…

    • 946 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    Abstract The purpose of this investigation is to determine whether the temperature can affect the reaction rate of enzyme activity. The enzyme activity was measured by five different temperatures, separated in tubes which later got measured by their height of foam after 10 minutes. Freshly-prepared potato juice was used as the enzyme for catalase. Since temperature is measured by the kinetic energy of molecules, the higher the temperature, the more movement of molecules. The lowest temperature…

    • 805 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    4.6 The Selection of the Injection Machine 4.6.1 Calculation of the Injection Volume Figure 4-8 shows the volume of plastic parts by Solidworks modeling. Figure 4-8 Volume of the Stress Cone Plastic parts volume: Vplastic = 4.198 × 10-5 m3 = 41.98 cm3 Plastic parts density: ρ = 1.2 g/cm3 Plastic parts quality: mplastic = ρVplastic = 1.2 × 41.98 = 50.376 g 4.6.2 Preliminary Estimation of the Gating System Although the gating system of condensate cannot determine the exact value prior…

    • 784 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    Fig.3 illustrates that the unsteadiness parameter reduces the dimensionless film thickness . Also, for critical value of the unsteadiness parameter the film thickness tends to zero. This implies the film thickness vanishes that this critical value and then the motion becomes impossible. One of the main objectives of this study is to discuss the surface tension effect, according to thermosolutal Marangoni convection effect, on the motion. The increase of the temperature surface tension…

    • 899 Words
    • 4 Pages
    Improved Essays
  • Great Essays

    Emily Melendez January 31, 2017 BSC2010 Enzyme I: pH and Temperature Lab Report Introduction: (2008, November 11). Without Enzyme, Biological Reaction Essential To Life Takes 2.3 Billion Years. Retrieved January 31, 2017. The basic concept that is being explored are about enzymes. Enzymes are proteins that are known for being sparkplugs in a chemical reaction. Enzymes have a shape and for them to ‘spark’ they must have the proper substrate for it to work U. This does not change the enzyme’s…

    • 2082 Words
    • 9 Pages
    Great Essays
  • Page 1 4 5 6 7 8 9 10 11 50