Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
12 Cards in this Set
- Front
- Back
When EAI is in the AUTO position but is on, what indications do you have? |
EAI on the N1 gauge |
|
Where is WAI shown on when it is in AUTO position? |
WAI will display next to the EGT gauge |
|
When do the INOP lights illuminate on the WINDOW HEAT switches? |
Overheat has occurred OR The switch is off OR System fault has occurred |
|
How is ice detected in flight? |
Two probes on the forward fuselage 2 senses: EAI on 10 senses: WAI on |
|
What happens when a leak is detected on the engine anti ice system? |
It has anti ice duct leak detection system which will close the engine anti ice valve for that engine |
|
When TAT is above 10C, wing anti ice is inhibited for how many minutes after liftoff in the AUTO/ON position? |
5 |
|
Automatic WAI operation is inhibited when? |
At any temperature AND Less than 10 minutes has elapsed since lift off Turning WAI to ON will override this feature |
|
If a WAI valve fails closed what happens to the opposite wing valve? |
It will close automatically to prevent asymmetrical wing anti-icing |
|
If a fault occurs with WINDOW HEAT how do you reset the window heat controller fault? |
Pushing a window heat switch OFF for 10 seconds, then ON |
|
When are pitot tubes and AoA probes supplied with heat? |
When either engine is operating |
|
What probe does not receive heat on the ground? |
TAT |
|
What is the backup system to the window heat? |
Antifog system operates automatically if primary window heat system fails |