• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/18

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

18 Cards in this Set

  • Front
  • Back

What two things must you take into consideration when selecting the wire size to use in an aircraft electrical system installation?

The current carrying capacity of the wire and the voltage drop caused by the current flow through the wire.

What is the maximum number of wires that should be connected to a single stud in a terminal strip?

4

How are wire bundles protected from chafing where the bundle goes through a hole in the fuselage frame or bulkhead?

Cover the edges of the hole with flexible grommets and the bundles are secured to the structure with cushioned clamps

What kind of clams are used to secure a wire bundle to aircraft structure?

Cushioned Clamps

Why are solderless splices usually better than soldered spices in the wiring of an aircraft electoral system.

Because the are less likely to be damaged from vibration

What size of generator must be used in an aircraft electrical system if the connected electrical load is 30 amps, and there is no way of monitoring the generator output?

If there's no possibility of monitoring the continuous connected electrical load it should not be more than 80% of the rated generator output, which about 37.5 amps or rounded up to 40 amps

On which wing is the red navigation light?

Left wing

What kind of fault can be found in a generator armature with a growler?

Shorted coils

Does an Aircraft engine electrical starter use a series or a parallel motor?

Series wound motor for great torque

What is the main disadvantage of aluminum wire over copper wire for using in aircraft electrical system?

Aluminum wire is brittle and more susceptible to breakage when nicked or subjected to vibration

What kind of rectifier is used in small DC alternators installed in most light aircraft?

6 Silicon diodes arranged in three phase full wave rectifier

What kind of instrument would you use to measure very high resistance?

Megohmeter or Megger the registered trade name of the instrument

When is it important that aircraft electrical system wire bundles be closed in some type of conduit?

When they are wired through areas subjected to rough handling and abrasions are likely

What size aluminum wire would be proper to replace a piece of 4 gauge copper wire

2 gauge wire

What is the smallest size aluminum wire that is approved for use in aircraft electrical systems?

6 gage wire

What three things must be synchronized before an aircraft AC generator is placed on the same bus with another AC generator?

The voltage, the frequency, and the phase rotation

How can the direction of rotation of the amateur of a DC-shunt wound electric motor be reversed?

Reverse the amateur or the shunt field coil connection with reference to the other

What is meant by flashing the field of a generator?

Restoring the residual magnetism to the frame of the generator. Done by passing battery current through the field coils in the normal direction of flow.