Landing Point Lab Report

Improved Essays
Results H1 H2 Landing spot ( ) Actual value (landing spot)
Trail one .26m .904m 96.96cm 96.8cm
Trail two .235m .904m 92.18cm 92cm Discussion questions
1) Equation for the landing point of the bob

2) Distance where the bob should land from directly beneath the rest position of the pendulum.

3) Would you expect the same result if you used the different mass?
If the experiment were to use a different mass the result would not differ as the length that the mass travels is independent on both the mass of the objects and the gravitational force which is acting upon it. However the landing position of the mass is dependent on the heights (h1 and h2).

4) How would your results
…show more content…
The centre of where the bob lands is hard to find because you will get two maybe three indentations on the paper. This will make it hard to find the exact distance from where the bob is launched to where it lands. There when comparing the calculated result to the measured result is could cause a millimetre different between the two. (see figure 4)

How the experiment was able to be undertaken
The mass was able to be launch through the use of moment because when the string was burnt using the match stick the weight was able to be launch without any additional force required to act upon it. For example if the mass was launched with by a human there would be a risk of adding extra force upon the mass causing the landing position to change.
The projectile was able to be launched because when the string was burnt on the opposite end to the razor blade the mass was able to swing at certain velocity allowing the string to be cut causing the projectile to be launched into the air and if calculation and measurements are correct, will allow the projectiles to land in the predicted area. (See figure

Related Documents

  • Decent Essays

    Spacer Lab Report

    • 393 Words
    • 2 Pages

    General procedure: One equivalent of spacer was coupled using 2.4 equivalents of inhibitor, 0.18 equivalents of copper sulfate, 0.36 equivalents of (+)-sodium-L-ascorbate, in a mixture of 10% H2O in DMF, 24 mL/mmol spacer. The mixture was placed in the microwave for 30 minutes at 80oC Pro6 Spacer (10) (30 mg, 0.036 mmol) and 18 (36 mg, 0.087 mmol) were dissolved in 778 µL DMF. Copper sulfate (1.62 mg, 0.006 mmol) and sodium-L- ascorbate (2.57 mg, 0.013 mmol) were dissolved in 86 µL H2O. The two solutions were combined in a microwave tube and put in the microwave for 30 minutes at 80oC. The solvent was evaporated under reduced pressure.…

    • 393 Words
    • 2 Pages
    Decent Essays
  • Decent Essays

    Unit 3 Physics Lab 3

    • 546 Words
    • 3 Pages

    Further, this experiment sought to clarify the circumstances under which the instruments fail to comply with expectations. Results/Data Part 1: The Motion Sensor Motion Sensor’s Measurement of Distance on ‘Short Range’ 1 m Closest Measurable Distance on ‘Short Range’ 0.12 m Closest Measurable Distance on ‘Long Range’ 0.12 m Distance from Center Line for First Detection of Block on ‘Short Range’ 0.05 m Distance from Center Line for First Detection of Block on ‘Long Range’ 0.055m Table 1:…

    • 546 Words
    • 3 Pages
    Decent Essays
  • Decent Essays

    Hand Graph Lab

    • 465 Words
    • 2 Pages

    Questions: Answer all questions given What kind of relationship did you see in your D vs T graphs (both hand and computer)? Do these relationships make sense? Explain! In the distance versus time graph for the hand graph, there is an exponential increase the in the distance traveled; as time progresses, the distance the car travels increases a little more, as the slope is not a straight line, but instead slopes upwards, with slopes later in the line being steeper than the slopes before.…

    • 465 Words
    • 2 Pages
    Decent Essays
  • Improved Essays

    Procedures How was the experiment carried out to answer the problem? Day 1 - Determining Flight Factors On the first day we discussed as a class what variables could affect the flight path of the balloon. This list included anything from the placement of the balloon in the slingshot to an innocent bird flying by while the balloon is in the air. Each factor was then sorted into a category of either a control variable or an act of god.…

    • 567 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    Physics Lab Worksheet

    • 585 Words
    • 3 Pages

    To fix both of these errors we could have either used more precise lab equipment that reduced friction and drag as much as possible as to not majorly impact our data, or we could have added calculations to account for the friction and drag to make our data more…

    • 585 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    Wind Erosion Lab Report

    • 480 Words
    • 2 Pages

    Adriana Alvarado Period 1 Nov. 7, 2017 Wind Erosion Background Information: Wind is caused by changes in pressure and temperature in the Earth’s atmosphere. Wind erosion occurs when rocks and sediments are picked up and moved to another place by ice, water, wind, or gravity. Wind weathering usually occurs during the rainfall. Due to the temperature changes of the sea caused by the sun, the temperature of the surface rises, and the land heats the air above it.…

    • 480 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Rotating Point Lab

    • 384 Words
    • 2 Pages

    Once we recorded the time for the mass to reach the floor, the data would be placed in the excel spreadsheet (as seen in Figure 2). To find rotational inertia, the equation I=mr2 had to be rearranged. The new equation resulted with I=1/12*m1(a2+l2) + 1/12*m2(a2+l2) + 1/12*m3(a2+l2) + 1/12*m4(a2+l2) + 1/12*m5(a2+l2) +1/12*m6(a2+l2). Once the rotational inertia was found, it was possible to break down each mass value and add them back together to get a value of .0128.…

    • 384 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Learning Projectile Motion via Potato Launchers (Prompt 2) Launching Potatoes through potato launchers may seem like an ordinary activity that people do to have fun but principles of physics are present in this activity. Launching Potatoes through Potato launchers is an example of projectile motion, it also shows how gravity can impact acceleration. Projectile motion occurs when an object is thrown and it moves along a curve due to gravity. The only force that a project has during projectile motion is gravity which causes a downward acceleration. These three principles of physics are present in such a simple activity.…

    • 416 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Specify the sources (causes) of friction. The causes of friction in this lab come from three different sources. One is the string sliding over the pulley wheel. Another is the pulley wheel turning on its axle.…

    • 467 Words
    • 2 Pages
    Improved Essays
  • Decent Essays

    Hello. Today we would like to talk about Darts. Have you ever tried Darts? There are various kinds of it, such as 01, cricket, count up and so on.…

    • 96 Words
    • 1 Pages
    Decent Essays
  • Improved Essays

    Pglo Lab Report

    • 1131 Words
    • 5 Pages

    Purpose: The overall goal of this lab was to perform a procedure on E. Coli which involved transferring genes that encoded for the green fluorescent protein into E. Coli to see if the transferred genes would make a difference on the growth and whether or not the bacteria would glow under UV light. Hypothesis: If the bacteria with the pGLO plasmid was grown on a plate containing LB and ampicillin then the bacteria will grow but not glow under UV light. If the bacteria with the pGLO plasmid was grown on a plate containing LB, ampicillin, and arabinose then it will be able to grow and glow under UV light. If the bacteria without pGLO plasmid was grown on a plate containing LB and ampicillin then it will not be able to grow or glow under UV light.…

    • 1131 Words
    • 5 Pages
    Improved Essays
  • Improved Essays

    More traditional tools for measuring mass are spring scales and triple beam balances. Discuss in terms of forces and torques how each of these tools can be used to determine the unknown mass of an object. Include in your discussion an explanation as to why mass measurements taken by a spring scale are affected by local variations in gravitational field strength, while those taken by a balance are not. The way a triple beam balance works has to do with the idea that equal masses on each side are being pulled downwards by gravity with equivalent forces.…

    • 1296 Words
    • 6 Pages
    Improved Essays
  • Improved Essays

    In this experiment, the objectives were to derive an equation for the tension in the string (which had a mass attached and was revolved in a vertical circle motion). In order to complete this, the velocity of the mass would have to be calculated using the measured tension, and this value would then be compared to the expected velocity. The second objective of this experiment was to observe how mass, velocity, and radius affect the tension of the string. These objectives were reached in this experiment. Before beginning the experiment, an equation had to be derived in order to calculate the velocity given the tensions of the string, the mass of the weight that the string would hold, and the radius of the string.…

    • 1038 Words
    • 5 Pages
    Improved Essays
  • Improved Essays

    Potential Energy Essay

    • 725 Words
    • 3 Pages

    For the first trial, no additional weights were added onto the glider + flag or the hanger. The air machine was turned on, and the photo-gate was positioned such that the speed of the glider could be measured after it has traveled a distance d, which was set to 0.50m. The photo-gate and flag on the glider were also both straightened. After that, the velocity of the glider (with flag) was measured. This experiment was repeated for 5 additional trials: The first two trials measured the velocity of the mass of glider + flag with no weights added to the hanger; an additional weight of .100 kg was added to the glider and flag for the second run. The other four trials measured the velocity of the glider with an additional 0.100 kg and 0.150 kg to the hanger.…

    • 725 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    Aim Simple Pendulum Experiment The aim of the experiment was to determine the effects of two factors (the length of a pendulum and the hanging mass of a pendulum) on the period of oscillation of the simple pendulum and to determine the value of g, the acceleration due to gravity. Apparatus Retort stand String…

    • 873 Words
    • 4 Pages
    Improved Essays