Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
16 Cards in this Set
- Front
- Back
Identify the components of a complete flight deck uniform.
|
-Cranial, long sleeve shirt/jersey, eye protection, hearing protection, long pants, flight decck boots
|
|
State the purpose of the HASBAR(Horizon Reference System).
|
Used by pilot as an artificial horizon during night shipboard ops.
|
|
Describe the components of the Landing configuration Lighting eqmnt.
|
-Stabilized Glide scope Indicator (SGLI)
-Wave off light system -Deck surface/hangar wash flood lights -Extended line up lights |
|
Describe the components of the VERTREP Light eqptment.
|
-Homing Beacon Light
-Deck Edge Lights -Overhead/FWD Structure Flood lights -HIFR Heading Lights -Deck Status Lights |
|
Whar are the 4 categories of Visual Landing Aids(VLA)?
|
-VERTREP Lighting Eqptmnt
-Landing Config. Lighting Eqptmtn -LAMPS MK III Lighting eqptmnt -Accessory Visual Aids |
|
Describe the flight deck markings for HIFR(Helicopter Inflight Refuelling).
|
-the letter "H" (located on the Port side)
-helo hovers w/ hose pickup point over the "H". |
|
Identify the personnel required for an aircraft move.
|
-(2) Wing walkers
-(1) brake rider -(1) Safety Observer -(1) Tow Tractor driver -(1) Director |
|
Wat is the proper position of the stabilizer during towing/parking of the helo?
|
-Level
|
|
What are the wind restrictions for folding tail/main rotors?
|
-no more than 45kt winds
|
|
name the 3 methods to fold the main rotor blades.
|
-electrically
-manually -balde fold test |
|
What are the tiedown/securing points on SH-60B?
|
- (2) on wheel hub (1 on each side)
-(2) 1 above each struts -(2) 1 above the tail wheel, on the aft transition section, on each side. |
|
Why is battery pwr required when folding the tail rotor pylon?
|
- to index (lock) the tail rotor so the blades won't turn.
|
|
What are the approved locations and proper procedures for a/c grding.
|
-apply to static grd and then connect one end to earth's grd.
-then apply other end to the a/c GRD receptacle(aft transistion section.) -Grd'ing must be checked regularly to ensure continuity. |
|
Explain why tie down deflection of blades must be 6-12" from static position.
|
- to prevent damage from excessive tightening from tied downs or wind flapping.
|
|
State the purposse of flight deck markings.
|
-Ensure enough clearance and proper positioning for evolutions being done.
|
|
Identify the VERTREP line onboard ship.
|
-"T"
-"Ball and "T" (used for larger aircraft) - Dash Lines |