Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
12 Cards in this Set
- Front
- Back
|
You should check the machined surfaces of the cylinder block for flatness using what two measuring tools? |
Straight edge Feeler gauge |
|
|
Misaligned main bearing bores could cause |
Excessive bearing wear or a broken crankshaft |
|
|
An underslung crank has the main bearing caps at the bottom of the crank |
True |
|
|
Which of the following should you (NOT) use to clean aluminum componentsidentif |
Hot caustic soak tank |
|
|
Identify two measuring tools that you use in order to check the main bearing bores on an engine block |
Inside micrometer Dial bore gauge |
|
|
You can repair cylinder liners on large engines by hard chrominance and grinding to size |
True |
|
|
Why do you use alloy cast iron for engine block material |
The alloy cast iron is strong |
|
|
Why must the outside diameter of a dry fit liner fit the cylinder block bore correctly |
To allow heat transfer from the liner to the block material To support the liner |
|
|
Wet type cylinder liners |
Are in direct contact with the coolant |
|
|
Leaking o-rings on a wet liner cause |
Coolant to enter the crankcase |
|
|
When reconditioning a cylinder bore, you can use a de-glazing hone to |
Restore cylinder wall crosshatch |
|
|
Identify four important checks that you must complete during a new cylinder liner installation |
Check cylinder bore for out-of-round, taper and cracks Check all seal surfaces Check liner counter bore Check liner protrusion height |
