Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
50 Cards in this Set
- Front
- Back
Which type of sling is appropreate for in high temperatures?
|
Chain
|
|
Which of the following synthetic ropes have the lowest safe working load rating?
|
Polypropylene
|
|
How would the SWL of a 3 or 4 part bridle sling be calculated?
|
Usually the same as a two-part sling
|
|
What is the safety factor of new wire rope used for general rigging?
|
Depends on the applications
|
|
Health and Safety on the job is:
|
The number one priority
|
|
When using two modified basket hitches in a single hook, the maximum angle separating the two slings must never exceed:
|
90 degrees
|
|
What do the terms "regular lay" and "lang lay" refer to?
|
Direction the wires are wound, relative to the direction the strands are wound.
|
|
The definition of a regular lay wire rope is
|
The wires that make up the strand twist clockwise and the strand is twisted counterclockwise (left
|
|
What lubricant can be used o the load chain of a chain fall?
|
Mineral/Machine Oil
|
|
The minimum wraps to be left on any drum according to Alberta Occupational Health and Safety regulations is
|
5
|
|
A true basket hitch, with a wire rope sling, has twice the capacity of a vertical hitch if the D/d ratio is _________ and if the wire rope is vertical
|
from 20:1 to 40:1
|
|
Which of the following would be considred coarse laid rope: 6 x 37, 6x7, 6x9
|
6x7
|
|
Fleet angle for a smooth drum is
|
1 1/2 Degrees
|
|
When cribbing a heavy load, what is the rule of thumb for the maximum
height of the cribbing? (Cribbing dunnage all set to the same length). |
The height should not be greater than the length of the dunnage
|
|
What is the rule of thumb for placing the first snatch block away from an air tugger?
|
15 drum widths
|
|
If the throat of a hook shows signs of distortion, a safe practice is to
|
Take it out of service
|
|
Which style of block is used to acheive a change of direction without having to reeve the wire rope through the block?
|
Snatch Block
|
|
The maximum number of parts of line that may be used when reeving fiber rope before friction loss is greater than mechanical advantage is:
|
8
|
|
When inspecting any type of block used for rigging purposes, we need to check:
|
Pins and axles, rope groove, bushings or bearings and end fittings
|
|
Prior to anchoring an air tugger to a structural column:
|
Ensure that an engineer has approved the connection
|
|
When spooling wire off of the top of a drum, if the anchor point is on the left and you are using right regular lay wire rope, how should the wire rope be wound on the drum?
|
Over wound from the left side of the drum
|
|
Which type of eye bolt should be used if there is any possibility of angular load
|
Shoulder Type
|
|
A shackle is sized by the
|
Bow
|
|
The included angle on a shackle bow using two slings should never exceed
|
90 Degrees
|
|
Shoulder-less eyebolts should only be used for
|
Vertical lift
|
|
There are two types of wire rope clips used in construction
|
Fist grip and saddle types
|
|
"Chain falls" and "come-a-longs" safety factor is
|
4 to 1
|
|
When operating a crane around new construction, which of the following conditions could be dangerous?
|
Outrigger pads set within the 45 degree line from the base of a trench or excavation
|
|
Boom deflection and pendant line stretch will increase
|
Long radius
|
|
A sudden start or stop produces a:
|
Shock Load
|
|
Excluding site policy, what percent of a crane's rated capacity is classed as a critical lift?
|
75%
|
|
Which of the following weather conditions could restrict or completely stop hoisting activities?
|
Wind Gusts
|
|
When using hand signals, you must
|
Ensure your signals are clearly visible to the operator
|
|
Which of the following factors would most seriously affect the performance of a conventional crawler?
|
Wind Velocities
|
|
Every boom section on a conventional with lattice boom must be clearly identified with which of the following?
|
Length, Serial #, Weight, Date of Inspection, Model #
|
|
A spool is rigged up to be cut out of a rack. As the cut is finished, the load drops suddenly, causing a condition known as
|
Shock Loading
|
|
Basic Type of boom truck
|
Articulating boom
|
|
If the hook does not hang dead centre from an extended boom on a boom truck, the problem would likely be
|
Truck not level
|
|
To determine the total load weight for a lift it is necessary to include
|
Any weight below the center line of the top shaeve
|
|
When rigging up any turntable mounted hoisting device, what is the most important thing to consider during setup?
|
Level the Machine
|
|
What is initially required to gain control of the load
|
Determine the Center of gravity
|
|
How is a stowed JIB kept in place?
|
Pins with retaining clips
|
|
When tower cranes are erected, the bolts are to be used
|
It doesn't matter if they are in good condition
|
|
Whenever two or more mcahines are in tight quarters, the operators should
|
Be in radio contact with each other
|
|
Tower cranes should not be operated when wind speeds reach
|
20-30 mph (30-50 k ph)
|
|
Tower cranes fastened to the outside of a building need to be secured every
|
Four Floors
|
|
Limit switch operation in a EOT crane should be checked
|
At the begining of each shift
|
|
Before moving a load with the trolley of an overhead crane, an operator should
|
Stop the crane and clear the area before proceeding
|
|
Three main objectives of successful rigging are
|
Safety, communication and control
|
|
Every removable section on an EOT crane must be clearly identified with which of the following?
|
Weight, Serial #, Date of Inspections, Model #
|