Reading...
Play button
Play button
Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
27 Cards in this Set
- Front
- Back
|
On-time takeoff is defined as....
|
5 min prior, 10 after
|
|
|
Do you make a 781 entry for FOD if you lose something in the cockpit?
|
Yea
|
|
|
Pilots will ensure they have a clearance beyond the end of the departure routing prior to reaching __ DME.
|
35
|
|
|
On departure from the outside runway, If the overhead pattern is open, maintain at or below _____ ft MSL until ____ DME.
|
2300ft, 2 DME
|
|
|
If carrying through initial on outside runway, maintain ______ feet MSL until intercepting the appropriate routing.
|
2800
|
|
|
When cleared the block, do not turn more than ___ degrees from a direct line to the assigned area.
|
45
|
|
|
When "CLEARED AREA (specified area), HIGH DEPARTURE," continue to WAYNO/JACOX stereo route until reaching FL____.
|
240
|
|
|
What are the low block / high block areas?
|
10,000-14,000 MSL LOW
16,000-20,000 MSL HIGH |
|
|
For local lost comm in VMC, remain outside ___ DME until on final.
|
10
|
|
|
When accomplishing an abort, ensure the yoke is in the _________ position in order to maintain weight on the main wheels and assist braking efficiency.
|
Neutral
|
|
|
If an engine failure occurs immediately after takeoff when using ACM OFF procedures, do not take it out of the OFF position until _____ ft AGL or clear of obstacles, whichever is higher.
|
2200ft
|
|
|
With EFCs off, engine spool-up tie will be _________.
|
increased.
|
|
|
Should the pressure in the high pressure refrigerant line exceed ____ psi, the OVER PRESSURE LOCKOUT switch, located on the nitrogen service panel, opens removing 28 VDC voltage to the soft start module. The compressor motor stops running.
|
320
|
|
|
T/F - The fresh air blower will not operate with the bleed air switch on or while the aircraft is in flight.
|
True
|
|
|
When the throttles are advanced to the takeoff position on the ground, the cabin is pressurized to a positive ___ to ____-foot differential.
|
80; 120
|
|
|
When operating properly, outflow valves will keep cabin pressure differential from exceeding ___ psi.
|
9.1
|
|
|
T/F - Do not depend on the CABIN PRESSURE HI annunciator to warn of a high cabin pressure differential situation.
|
True
|
|
|
Does the cabin dump valve have a safety wire on it?
|
Yes
|
|
|
The ice detector senses the formation of ice (approximately ___ inch), before the amber ICING annunciator illuminates.
|
.02
|
|
|
T/F - It is permissible to fly in icing conditions with inoperative horizontal stabilizer anti-ice and deice as long as you have tested them on the ground.
|
False
|
|
|
Flight in visible moisture without pitot heat can result in erratic operation of:
|
ASI
VSI Altimeter |
|
|
What is unreliable when windshield heat is set to HIGH or the side window defog heater/blower units are operating?
|
Magnetic compass
|
|
|
For the windshield wipers, if you want to "PARK" them, how do you do it?
|
Go to OFF, then PARK..... don't go straight from ON to PARK
|
|
|
The AOA indicator and indexer signals are provided by the computer dedicated to the _____ system.
|
Left
|
|
|
What position on the AOA gauge is L/D Max?
|
0.6
|
|
|
Not setting up the V/VS dial next to the AOA gauge (the one we set to 1.2 and 1.3) can result in what?
|
Erroneous on-speed indication
|
|
|
Can you disengage the autopilot if you exert enough manual force on the yoke?
|
Nope, it'll just trim against the force applied
|
