Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
39 Cards in this Set
- Front
- Back
FORMAT:
First Officer Prompt: "__________" ; Captain Reply: "__________" FO: "First Officer" C: "Captain" NOTE: student may use prompts, cockpit diagrams, posters, and Quick Study Guide as references during check |
EXAMPLE:
FO: "Selector Valves" C:: "Normal" "-" means status that must be verified ":" means action that must be taken or verified, or FO prompt to be followed by statement "::" means action Captain must take |
|
FO: "Flight compartment safety inspection & external walkaround"
|
C:: "Completed"
|
|
FO: "Pedals, seat, & harness"
|
C:: "Adjusted"
|
|
FO: "Selector Valves"
|
C:: Selector valves - up and guarded
C: "Normal" |
|
FO: "O2 Test";
NOTE: Both P and FO perform O2 mask test without prompting each step of the test. |
C:: Verify O2 Pressure (1410+) on ED2 (right of EICAS) adequate by table, need not memorize table
C:: Check Mic is operational select "MASK" on radio panel (bottom of center console), then tap mask and listen to speakers C:: Verify regulator flow at 100% (switch under O2 line on mask) C:: Push "TEST/RESET" Lever, listen for airflow and look for yellow cross to verify flow. Then, squeeze mask release paddles. Release paddles then push emergency flow control (red dial at bottom of mask compartment) and verify yellow cross. Release emergency flow control and TEST/RESET Lever. C:: "O2 mask checked at ___ PSI" |
|
FO: "Electrics"
|
C:: DC service switch - OFF
BATTERY MASTER - ON IDG Disconnects - Guarded and dark APU GEN switch - As required GEN 1 & 2 switches - OFF/RESET switchlights (PBAs) - Flush, no lights (dark cockpit) C:: "Electronics Checked" |
|
FO: "Fire Protection" (warning portion)
|
C:: ED1: No FIRE FAIL messages
Loop switches (5) - BOTH TEST switch - hold at WARN audio - warnings Master Warning PBA - illuminated: reset (either one) RH... and LH ENG and APU FIRE PUSH PBAs - illuminated Firex bottle discharge buttons - armed ED1 Fire warnings (one for each test loop, 5) - displayed After 10 sec delay; Master caution PBAs - illuminated 1chime - sounds Master caution PBAs - reset (either one) ED1: Check for SOV caution messages (5) - displayed TEST switch: release All fire detection indications - removed [Fire protection test continued on next slide] |
|
FIRE PROTECTION TEST, CONTINUED (fail portion)
|
TEST switch:: select and hold FAIL
Master caution PBA - illuminated audio - warning (1chime) ED1 - caution messages (5) - displayed Test switch: release All fire detection indications - removed [Fire protection test continued on next slide] |
|
FIRE PROTECTION TEST, CONTINUED (Firex monitor panel)
|
ENGINE BOTTLE 1 & 2 switches: select and hold both
advisory messages (4) - squib cautions displayed ENGINE BOTTLE 1 & 2 switches: release Firex advisory messages - removed C:: "Fire Protection Checked" |
|
FO: "Lights"
|
C:: State position,
"NAV lights ON, LOGO and Wing INSP lights _____ (as required)" |
|
FO: "Fuel"
|
C:: boost pumps off - L BOOST PUMP and R BOOST PUMP PBAs: OFF - INOP lights illuminated
GRAVITY XFLOW PBA: OFF - dark XFLOW AUTO OVERRIDE panel PBAs: OFF - all dark C:: "Fuel Checked" |
|
FO: "Bleeds" (ducts)
|
C:: Bleed air ducts overheat detection system test
DUCT MON rotary switch: TEST, hold audio - warnings ED1 - duct warnings appear ED2 - DUCT TEST OK BLEED AIR panel warnings - L and R 14th STAGE PBAs - DUCT FAIL; L and R 10th STAGE PBAs - DUCT FAIL ANTI-ICE Panel - WING TEST switchlight - DUCT FAIL DUCT MON rotary switch: release - messages removed BLEED AIR L and R 14th STAGE PBAs: CLOSED BLEED AIR 14th STAGE ISOL PBA: CLOSED BLEED AIR L and R 10th STAGE PBAs: CLOSED C: "Bleeds set" |
|
FO: "APU"
|
C:: State position
|
|
FO: "START PANEL"
|
C:: L-ENG-R START PBAs: OFF
IGNITION A and B PBAs: OFF IGNITION CONT PBA: OFF C: "Checked" |
|
FO: "Hydraulics"
|
C:: EICAS: hydraulic synoptic page
AC Motor Pumps (ACMPs): 1B - ON, 3A - OFF, 3B - ON, 2B - ON (all up) HYD synoptic page - 45% to 85% total volume, reservoir lines - green, pressure - 3000 PSI ACMPs: 1B - AUTO, 3A - ON, 3B - AUTO, 2B - AUTO HYD synoptic page - 3A pressure at 3000 PSI C: cancel master caution switchlight |
|
FO: "ELT"
|
C:: PASS OXY PBA - Guarded, no light
C: "ELT Armed" |
|
FO: "Pressurization"
|
C:: MAN ALT - Centered
EMER DEPRESS PBA - Guarded, off, dark PRESS CONT PBA - off, dark MAN RATE knob: full DECR C: "Pressurization Checked" |
|
FO: "Air Conditioning"
|
C:: L PACK, R PACK PBAs - as required
RAM AIR PBA - guarded, off, dark Temperature control MAN PBAs - off, dark CARGO FAN switch: ON ANTI-ICE, WING switch: OFF ANTI-ICE, COWL LH and RH switches: OFF C: "Air conditioning checked" |
|
FO: "Ice Detection Test"
|
C:: ANTI-ICE, DET TEST switch: press in
IFF wing leading edge internal temperature < 18C - ICE caution message and ICE light on IFF wing leading edge internal temperature > 18C - ICE advisory message on C: "Ice detection test complete" |
|
FO: "Windshield Heat"
|
C:: WSHLD LH and RH toggles: LOW
ED1 - L WSHLD HEAD, R WSHLD HEAD caution messages - removed PROBES, LH and RH toggles: OFF C: "Windshield and heat checked" |
|
FO: NO ACTION (verify captain moves to MISC LTS and PASS SIGNS panels)
|
C:: MISC LTS: DOME LIGHT - as required, STBY COMP - as required, OVHD - as required
PASS SIGNS: NO SMOKING: ON, SEAT BLTS: OFF C: "Miscellaneous and passenger lights checked." |
|
FO: "Emergency Lights"
|
C:: EMER LTS swtich: ARMED
ED1 - EMER LTS OFF caution message removed C: "Emergency Lights Armed" |
|
FO: "Standby Compass"
|
C:: Compare standby compass heading with PFD/MFD - verify acceptable deviation
NOTE: AHRS information may be inaccurate due to ground equipment magnetic disturbance C: "Standby Compass Checked" |
|
FO: "Stall Test"
|
C:: Stall Protection System Test
STALL PTCT PUSHER switches: ON STALL PBA: Press and release Left shaker - active ED2 - CONT IGNITION Start Panel - CONT PBA ON Right shaker - active Stick pusher - activated STALL PBA - flash stall mechanisms - OFF CONT IGNITION - off C: "Stall test complete" |
|
FO: "EGPWS Test" OR "Emergency Ground Proximity/Wind Sheer Test"
|
C:: PULL UP / GND PROX PBA: Press and release - audio warnings sound
PULL UP and GND PROX PBAs - flash ED2 - 3 fail messages PFD - WINDSHEAR warning and caution message MFD - TERRAIN TEST and TERRAIN DISPLAY FAIL show test pattern after a few seconds, all warnings removed and lights dark. |
|
FO: "Nosewheel steering"
|
C:: Nosewheel steering - OFF
C: "Nosewheel steering off" |
|
FO: "Clocks"
|
C:: Check correct clock time
C: "Clocks set" |
|
FO: "EFIS Control Panels"
|
C:: Navigation items - as needed
Remove DH, MDA, and RA TEST from PFD Barometer: SET to current C: "EFIS checked" |
|
FO: "Instrument Panels"
|
C:: PFD and MFD - appear normal
C: "Checked" |
|
FO: "EICAS and Standby Instruments"
|
C:: ED1 and ED2 - appear normal
Standby Attitude Indicator, Compass, and Altimeter - set to current and appear normal C: "EICAS and Standby Instruments Checked" |
|
FO: "Upper Pedestal"
|
C:: MLG BAY switch: hold in OVHT position - audio warnings
ED1 - MLG BAY OVHT MLG BAY OVHT: Release - message disappears OVHT TEST switch: hold in WARN FAIL position - audio warnings ED1 - MLG OVHT FAIL OVHT TEST switch: release - message disappears C: "Landing gear fire detection test complete" |
|
FO: "Thrust Lever Quadrant"
|
C:: DISC handles - aligned with their axis
SPOILERS - AUTO THRUST REVERSERS: LH and RH switches: ARMED ED2 - L and R REV ARMED EMER STOW PBAs - out and dark FLIGHT SPOILERS handle: RETRACT Thrust Levers: FUEL SHUT OFF GPWS FLAP OVRD switch - NORM and guarded FLAPS: 0 degrees "Thrust quadrant check complete" |
|
FO: "Avionics"
|
C:: Radio tuning units - no fail messages
C: "Checked" |
|
FO: "APR Switch"
|
C:: APR switch - ARMED
C: "APR Armed" |
|
FO: "Engine Speed Switches"
|
C:: ENGINE SPEED switches: ON
C: "Engine Speed Switches on" |
|
FO: "Trims"
|
C:: AIL and RUD TRIM: check free movement in both directions (white), reset to neutral (green)
C: "Trim checked" |
|
FO: "Yaw damper"
|
C:: YD1 and YD2: ENGAGE (on and lit)
ED1 and 2 and PFD 1 and 2 caution messages removed C: "Yaw Dampers Engaged" |
|
FO: "Source Select Panel"
|
C:: Source selectors (4) - all normal
C: "Source selectors normal" |
|
FO: "Lower Pedestal"
|
C:: Observer ACP - set as required
Transmit Switch - INT SVC LANDING GEAR MANUAL RELEASE handle: stowed (in) ADG Manual Deploy Handle - stowed |