Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
59 Cards in this Set
- Front
- Back
People need safe and pleasant water to drink. |
True |
|
Cities and towns need qualified capable and dedicated water distribution system operators |
True |
|
All waters regardless of the source for treatment received, should be disinfected to prevent the spread of disease causing organisms |
True |
|
What is the main responsibility of water distribution system operators |
The health and well-being of the community they serve |
|
What is the purpose of adequate and reliable records |
To document the effectiveness of the operation |
|
What is one of the best results from a well - guided tour |
Gaining support to obtain the funds necessary to run a good operation |
|
What should you do after investigating the drinking water complaint ? |
Notify the person who complained, of the results and what corrective action was or will be taken |
|
As a water distribution system operator what does your total reward depend on |
How you apply yourself |
|
What kinds of tasks do water distribution system operators perform at Water Supply facilities ? |
Maintain, Manange, Operate, Repair |
|
A water Supply system delivers water from its source to which ultimate customers? |
businesses, homes, and industrial water users |
|
Which items are types of operational service storage tanks in water Distribution Systems? |
elevated tanks, ground-level tanks, pressure tanks and underground facilities |
|
What does a water distribution system consists of ? |
fire hydrants, meters, network of pipes, service lines, and valves |
|
Which items are typical duties of a water distribution system operator ? |
✦ evacuate trenches and install Shoring ✦flush and clean water mains ✦ Lay, connect, test and disinfect water mains ✦ place barricades signs and traffic cones around work sites to protect operators and the public ✦ TAP INTO WATER MAINS |
|
Which items are typical duties of a water distribution system operator ? |
ANSWER IN PICTURE ↑↑↑↑↑ |
|
A Water distribution system operator may be responsible for which supervision and administration tasks? |
~ encouraging operators to strive for higher levels of certification ~ giving advice on budget requirements ~ give advice on future planning ~ keeping adequate and reliable records ~ training new operators |
|
The difference between the static ground water level and the pumping level is the |
drawdown |
|
A customer complaint about the presence of brown floc in tap water can best be handled by |
investigating the problem as soon as possible |
|
The term "aquifer" relates to which of the following... surface water, a lake, stream or groundwater |
groundwater |
|
One indication of corrosive water is a high concentration of |
carbon dioxide |
|
Cathodic protection means protection against |
corrosion |
|
The primary reason for the use of a dry barrel fire hydrant is to |
keep the hydrant from freezing |
|
The component parts of a well include all of the following except sanitary seal, well screen, pressure switch, cement grout |
pressure switch |
|
At the same barometric pressure, the amount of dissolved oxygen in cold water tends to be ________ the amount of dissolved oxygen in warm water. |
more than |
|
Water Storage facilities are used to store water from Wells or water treatment facilities at times when the demands for water are high and to distribute the water during periods of low demand.... true or false |
True |
|
Hydropneumatic tanks must contain the proper amount of _______ to be effective. |
Air |
|
What is the main purpose of a water storage facility ? |
To provide a sufficient amount of water to average or equalize the daily demands on the water supply system |
|
What is a limitation of elevated tanks ? |
The pressure in the distribution system may vary with the water level in the tank |
|
|
Answer is # 4 |
|
|
Answer is # 1 |
|
Why must care be used when operating and maintaining hydropneumatic tank facilities, especially the pressure relief valves ? |
Because of high pressure in the tank |
|
the capacity of a clear well should be sufficient to allow a Water Filtration plant to operate at what rate ? |
At a constant rate during periods of peak demands |
|
|
ANSWER = 2, 3 & 5 |
|
How can automatic water level regulation be achieved in storage tanks and reservoirs ? By using |
Altitude-control valve |
|
Chemical water quality problems may be caused by |
Leaching of chemicals from tank linings or coatings |
|
What is breakpoint chlorination ? |
The addition of chlorine to water or wastewater until the chlorine demand has been satisfied |
|
When is the best time of year to take a water storage facility out of service for complete cleaning and inspection |
During the period of lowest water consumption |
|
What is disinfection |
The inactivation or destruction of disease-producing organisms |
|
Why is sodium thiosulfate added to a bacteriological sampling bottle before it is sterilized |
To neutralize all chlorine in the water |
|
During Sub-Zero temperature conditions, how can ice formations in water storage tanks be minimized? |
By continuously fluctuating water surface levels |
|
|
ANSWER 1,2,3 & 4 |
|
What are the types of water storage facilities common to a water supply system ? |
Clear Wells, elevated tanks, ground-level storage tanks, Hydropneumatic or pressure tanks and standpipes. |
|
When compared with elevated storage tanks, why are standpipes preferred |
Because they are: - easier to maintain - more accessible for observation - more accessible for sampling to determine the quality of the stored water - safer to work around |
|
|
2, 3, & 5 |
|
|
1 & 5 |
|
|
ALL |
|
|
ALL |
|
|
3 & 5 |
|
|
3 & 4 |
|
One indication of corrosive water is a high concentration of |
carbon dioxide. |
|
Which of the following is the principal constituent in water that causes corrosion of metals ? a. alkalinity b. dissolved oxygen c. hydrogen sulfide d. sodium chloride |
dissolved oxygen |
|
A record containing the size, location, and ties of water mains; valves; hydrants; tanks; reservoirs; and pump stations is called a |
comprehensive map |
|
Velocity of flow in Mains is usually expressed in terms of |
Feet Per Second |
|
_______ And ________ methods can be used to remove high iron content from a well Supply |
Oxidation , Filtration |
|
Hardness me be expressed in |
milligrams per litre as CaCO3 |
|
The basic unit of electrical power is the |
watt |
|
Check valves are used to |
permit flow in only one direction. |
|
The water table is defined as the |
upper surface of the groundwater |
|
A coupon test installation in a distribution system is used to |
determine the rate of scaling or corrosion |
|
The component of a centfifugal pump sometimes installed on the end of a suction pipe to hold the priming is known as a |
foot valve |