Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
56 Cards in this Set
- Front
- Back
|
_____ is not necessary for SCCP phones because they get the time using signaling. A. DHCP B. NTP C. DNS D. TFTP |
NTP |
|
|
Using ______, an interactive voice response (IVR) server enhances the Autoregister and BAT functionality, providing an automated method of adding potentially thousands of phones at a time. A. Manual Configuration B. Autoregistration C. BAT D. TAPS |
TAPS |
|
|
The basic steps to setp the DHCP service in CUCM are: I. Click add new II. Select server running the DHCP Monitor Server from the pull-down III. Configure the desired settings IV. Navigate to System > DHCP > DHCP Server In which order are these steps performed? A. I, II, III, IV B. IV, I, II, III C. IV, I, III, II D. I, III, II, IV |
IV, I, II, III |
|
|
A CM group is a bottom-up ordered list of redundant subscriber servers to which the phones can register. True/False |
False |
|
|
CUCM includes a basic DHCP server capability which recommends only up to 1000 IP phones due to high cpu load. True/False |
True |
|
|
In IP phone configuration requirements, what happens, by default, to a call when the bandwidth remaining is not enough to support another call at a given bit rate? A. Call is dropped or can get rerouted to a PSTN given the right settings. B. Call waits until enough bandwidth is accessible, then continues call normally C. The call goes through uninterrupted and functions normally D. An automated voice tells you toplease hold patiently and enjoy the music-on-hold |
Call is dropped or can get rerouted to a PSTN given the right settings. |
|
|
User account information is divided into three categories. Which settings include User ID, Department and Phone number/Mail ID? A. CUCM Configuration Settings B. Password Information C. Personal and Organizational Settings D. Credential Settings |
Personal and Organizational Settings |
|
|
How many LDAP servers can be used for redundancy? A. 3 B. 5 C. 4 D. 12 |
3 |
|
|
What are the three main methods end users can be added to the CUCM database? A. Manual B. Bulk Import C. LDAP Synchronization D. LDAP Authentication |
Manual Bulk Import LDAP Synchronization |
|
|
When auto registering a new IP Phone, what is the default range for DN's being used? A. 1000-1999 B. 2000-2999 C. 3000-3999 D. 4000-4999 |
1000-1999 |
|
|
Name five pieces of information that is provided through DHCP to IP phones. -IP address -Subnet mask -PoE assignment -Default gateway -DNS servers -NTP parent TFTP servers |
IP Address Subnet Mask Default Gateway DNS servers TFTP Servers |
|
|
DNS is service that is always recommended for use with IP Phones. True/False |
False |
|
|
What is important to preconfigure for use with TAPS?
A. CAR reporting B. IP_IVR server C. Credential Policy D. LDAP Synchronization |
IP_IVR server |
|
|
List in order the LDAP Sync configuration steps. I. Configure LDAP Directory II. Configure LDAP System III. Activate Cisco DirSync service IV. Configure LDAP Custom Filters A. I, II, III, IV B. III, I, IV, II C. II, III, I, IV D. III, II, I, IV |
III, II, I, IV |
|
|
Which of the following is not a LDAP attribute (that could be mapped) to become the CUCM User ID attribute. A. SN B. sAMAccountName C. UID D. Mail |
SN |
|
|
What are 4 ways IP Phones can be added to CUCM? A. Auto Register Phone Tool B. DirSync C. Bulk Administration Tool D. Manual Configuration E. Auto Administration Batch Tool F. Autoregistration G. CAR Tool |
Auto Register Phone Tool Bulk Administration Tool Manual Configuration Autoregistration |
|
|
What functions rely on proper NTP configurations? A. BAT B. CDR C. CMR D. TAPS |
CDR, CMR |
|
|
Which of the following services offered by CUCM are not necessary for IP phones in order to operate? A. DHCP B. PoE C. TFTP D. DNS |
DNS |
|
|
How many phones does DHCP support in CUCM? A. 1000 B. 1500 C. 2000 D. 2500 |
1000 |
|
|
Device settings provide a set of common configurations to a group of devices. True/False |
False |
|
|
What defines a top-down ordered list of redundant subscriber servers to which phones can register? A. Device Pool B. Cisco Unified CM Group C. Region D. Location |
Cisco Unified CM Group |
|
|
What is not a spec for a strong password? A. Cannot include consecutive numbers or characters. B. Must contain at least three different numbers or letters. C. Cannot include an alias D. Cannot use the same number or character more than three times consecutively |
Must contain at least three different numbers or letters |
|
|
Which standard provides network-based time synchronization? A. CDP B. NTP C. TFTp D. DNS |
NTP |
|
|
Which standard is it recommended that you eliminate reliance upon from your IP Phones? A. CDP B. NTP C. TFTP D. DNS |
DNS |
|
|
In manual configuration of IP Phones, which of the following are required fields that you must manually fill in? (Choose all that apply) A. IP Address B. MAC Address C. Device Pool D. Device Security Profile |
MAC Address, Device Pool, Device Security Profile |
|
|
What are the two ways CUCM can interact with LDAP? A. LDAP Sync B. LDAP Association C. LDAP Authentication D. LDAP Authorization |
LDAP Sync, LDAP Authentication |
|
|
Which standard is a Cisco-proprietary protocol that provides network mapping information to directly connected Cisco devices? A. CDP B. NTP C. TFTP D. DNS |
CDP |
|
|
For some third party SIP phones, it may be necessary to specify option 65. True/False |
False |
|
|
Which IP phone configuration requirement is a virtual assignment that allows the system designer to control the bit rate for calls? A. Location B. Region C. SIP Profile D. Common Phone Profile |
Region |
|
|
Which of the following are ways to add phones with CUCM? A. Auto Configuration B. Auto Registration C. Bulk Register Tool D. Auto Administration Phone Tool |
Auto-Registration |
|
|
What type of user is not included in the user directory? A. End Users B. CUCM Users C. Application Users D. User Account |
Application Users |
|
|
What is the first step in setting up LDAP Synchronization? A. Configure the LDAP System B. Activate the Cisco DirSync Service C. Activate the Cisco CucmSync service D. Configure the LDAP Directory |
Active the Cisco DirSync service |
|
|
Where can you edit the text that displays on the phone to describe the line? A. Display B. Alerting Name C. Line Text Label D. Internal Text Label |
Line Text Label |
|
|
Application users are people who type in a username and password into a log in screen (usually a webpage( to access features or controls. True/False |
False |
|
|
What port mode should you put the switch interface in that connects to the CUCM? A. Switchport mode trunk B. Switchport mode fast C. Switchport mode dot1q D. Switchport mode access |
Switchport mode trunk |
|
|
What function was added in CUCM 8.X, that intelligently triggers either a Reset or Restart depending on what changes were made to the device? A. Reset B. Restart C. Apply Config D. Apply Reset/Restart |
Apply Config |
|
|
If LDAP Authentication is enabled and LDAP fails or is inaccessible, the only End User account that will be able to log on to the CUCM system is the Data Administrator account defined during install. True/False |
False |
|
|
Out of the following protocols, which is the most critical? A. TFTP B. DNS C. DHCP D. NTP |
TFTP |
|
|
What allows administrators to perform database inserts, modifications, or deletions in bulk? A. BAT B. TAPS C. PAT D. LDAP |
BAT |
|
|
Under which CUCM interface allows the administrator to ping other IP devices, and what is it’s https address? A. https://<ip addr>/ccmservice B. Cisco Unified Presence Administration C. https://<ip addr>/cupadmin D. Cisco Unified Serviceability E. Cisco Unified Operating System Administration F. Cisco Unified Serviceability G. https:///cmplatform E. Cisco Unified Presence Administration |
Cisco Unified Operating System Administration, https://<ip addr>/cmplatform |
|
|
Where can SNMP connectivity and authentication be configured? A. Cisco Unified Presence Administration - SNMP B. Cisco Unified Serviceability Administration - SNMP menu C. Cisco Unified Operating System Administration - SNMP menu D. Cisco Unified Operating System Administration |
Cisco Unified Serviceability Adminstration - SNMP Menu |
|
|
What are the three possible privileges assigned to each resource? A. write B. No Access C. Change D. Read E. Update F. Full G. Traverse |
No Access, Read, Update |
|
|
Where is CUPS messaging be configured with external databases? A Cisco Unified Serviceability - Messaging B. Cisco Unified Presence Adminsitration - Messaging C. Cisco Unified Presence Server - Messaging D. Cisco Unified Operating System Administration - messaging |
Where is cups messaging be confugred with external database? Cisco Unified Presence Administration - Messaging |
|
|
Which CUCM menu provides man options to perform repetitive configuration tasks in an automated way? A. Device Menu B. Bulk Adminstration Menu C. Help Menu D. Advaced Feature Menu |
Bulk Administration Menu |
|
|
The CUCM application defines how many Standard groups by default? A. 10 B. 12 C. 28 D. 50 |
28 |
|
|
The CUC Administration interface uses a tree structure similar to _______. A. Windows Explorer B Linux C. Cisco CLI D. MS Dos |
Windows Explorer |
|
|
How is the CLI securely accessed? A. Telnet B. SSH C. Direct Connection D. GUI |
SSH |
|
|
Which of the following is the correct https link for Cisco Unified Operating System Administration? https://ip-address/cuadmin https://ip-address/cmservice https://ip-address/cmplatform https://ip-address/cuservice |
https://ip-address/cuservice |
|
|
What menu includes VoiceMail integrations, Inter-company Media Engine Configuration, Extension Mobility Cross-Cluster, and VPN features? A. System menu B. Media Resources menu C. Call Routing menu D. Advanced Features menu |
Advanced Features Menu |
|
|
Which of the following best describes the interaction between CUCM users, access control groups, and roles? A. User accounts can be assigned a role, which defines the user’s administrative role in the company. Users may be placed into access control groups to allow simpler directory searches. B. Access control groups are associated with one or more roles that define a level of privilege to an application’s resources. The user inherits those privileges when they are added to the access control group. C. Of the 46 roles defined by default, only 12 are active. Others must be activated via the Unified Serviceability interface. D. One group and one role are defined by default (the standard CCM super users group and the standard CCM admin users role). Other custom access control groups and roles can be defined by the administrator. |
Access control groups are associated with one or more roles that define a level of privilege to an application’s resources. The user inherits those privileges when they are added to the access control group. |
|
|
What menu under CUPS Administration allows you to access system status and troubleshooting tools, plus a system dashboard for quick review of system configurations? A. Applications B. Diagnostics C. Bulk Administration D. System |
Diagnostics |
|
|
What role allows you to have full access to a resource, including editing and modification (and deletion where applicable)? A. Write B. Read C. Update D. Manage |
Update |
|
|
Within the CUPS Administration menus, what provides integration configuration for the CUCM, definition of the inbound and outbound Access Control Lists, and Licensing status and management? A. System B. Messaging C. Application D. User Management E. Bulk Administration F. Presence |
System |
|
|
Custom groups can be created and associated with Standard or Custom Roles to exactly meet administrative requirements. True/False |
True |
|
|
Under Cisco Unity Connection Administration, what function will provide a way to define common settings for Users, Contacts, or Call Handlers? A. Contacts B. Users C. Distribution Lists D. Templates |
Templates |
|
|
What additional application does CUC provide for troubleshooting, with tools to define alarms, traces and logs among other things? A. Cisco Unity Call Serviceability B. Telephony Integrations C. Cisco Unity Connection Serviceability D. Cisco Unified Connection Serviceability |
Cisco Unity Connection Serviceability |
