Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
11 Cards in this Set
- Front
- Back
Why are compressor washer performed and what methods are commonly used? |
To remove any contaminants from the compressor section and improve engine performance. The fluid wash and abrasive grit wash are commonly used. |
|
How can you tell if a turbofan or turbojet engine is out of trim? |
There will be a high exhaust gas temperature at the target engine pressure ratio for takeoff power. |
|
Name the different types of compressor blade damage that may be found during inspection. |
Dents, cracks, galling, pitting, scratches, burrs, burns, gouges. |
|
What kind of markers can be used to mark the parts in hot and cold sections during repair? |
Layout dye, felt tip marker, chalk. |
|
How does relative humidity affect turbine engines? |
Negligible effect. |
|
What criteria determines replacement of life limited turbine engine components? |
Cycles, hours, and/or calendar time. |
|
If turbine blades are removed from a turbine disc, why should they be reinstalled in the same location? |
To maintain the balance of the turbine wheel. |
|
How are gas turbine engine tachometers calibrated? |
They are calibrated in percent r.p.m. |
|
On a turbine engine, what is the engine pressure ratio and what does it indicate? |
It is the ratio between the total inlet pressure and total turbine exhaust pressure and is used to indicate the thrust developed by the engine. |
|
On a turbine engine, what does exhaust gas temperature indicate and how is it obtained? |
EGT is the average temperature of the turbine of the turbine discharge gasses and is obtained by thermocouples placed near the turbine exit. |
|
Can the EGT system on a turbine engine be checked without running the engine? |
Yes, by checking the resistance of the thermocouples and circuits. |