Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
14 Cards in this Set
- Front
- Back
|
Standard units of linear measurement |
Inch, meter |
|
|
What point should you begin measuring at when using a steel rule |
1st major division |
|
|
What's the smallest division usually found on a folding rule |
1/16 |
|
|
What part of a rule should you measure from |
The edge |
|
|
What are the simplest and least accurate calipers |
Firm joint |
|
|
What caliper should be used to measure the inside diameter of a hole |
Inside caliper |
|
|
What makes a caliper more accurate |
A vernier scale |
|
|
The main part of a micrometer |
Spindle |
|
|
How do you adjust a micrometer caliper |
By turning the thimble |
|
|
On micrometers how far does a complete revolution move the spindle |
.025 in |
|
|
What micrometer is used for measuring sheet material |
Deep throat micrometer |
|
|
What part of a tube micrometer is at a right angle to the spindle |
Anvil |
|
|
How long is a framing square body, it's tongue? |
24, 16 |
|
|
What are the three heads used with a combination square? |
Protractor, square, and center heads |
