Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
26 Cards in this Set
- Front
- Back
Used to create a restriction of flow within the BHA.
|
Helix Plenum
|
|
Controls the flow and restriction of mud into the plenum.
|
Pulser
|
|
What are the four different types of pulsers.
|
Newsco
General Electric Phoenix APS |
|
Tool that measures radioactive properties in the formation and is typically the shortest probe in the MWD string.
|
Gamma
|
|
Unit contains accelerometers and magnetometers which produce surveys and other down hole information.
|
Directional Unit (DU)
|
|
It is considered to be the brains of the entire tool, commanding all functions and the distribution of power.
|
DU
|
|
This probe is the longest in the MWD string.
|
DU
|
|
Who are the two manufacturers of DU's?
|
General Electric
XXT |
|
Supply power to the electronics, gamma, pulser, and vibration sensor.
|
Batteries
|
|
Used to hoist the MWD string into the monel.
|
Spear point
|
|
Measures vibration down hole on the X, Y, Zach axis, and is programed to record peak values.
|
Vibration sensor
|
|
A battery connected directly below the DU will always be ?
|
Battery 1
|
|
A battery connected directly above the DU will always be ?
|
Battery 2
|
|
If both batteries were placed above the DU then ?
|
Lower would be battery 2 and the one further up is battery 1
|
|
Determine the tool to be used based on ?
|
Hours
|
|
The "D" in the fin should always point ?
|
up
|
|
GE measures _____from the pin end seal of the probe.
|
36.25
|
|
XXT measures ____ from the pin end seal of the probe.
|
34"
|
|
Gamma measures ____ from the pin end seal of the probe.
|
30.25"
|
|
When torquing batteries, the barrel wrench should not be placed on the ____.
|
vent plug
|
|
How many back turns are made before making a tool connection?
|
2 times
|
|
Are all the connections on the Pulser torqued individually?
|
no
|
|
When breaking tool apart, the first two breaks are going to be ___ and ___.
|
Spear point and helix plenum
|
|
The poppet nut should be torqued to ___ ft/lbs.
|
40
|
|
When doing a tool ring out while pulsing where would you start?
|
Red 7 wait 5 secs and then red 6 after 45 or 60 sec depending on TxDT setting
|
|
What are the lower end O-rings?
|
218 and 220 - plenum
014 - piston cap orifice 126 and 128 -piston shoulder 119 and 121 helix 029 (2) - inside plenum poly pack - piston cap |