The Punch In

Front 1

How do you prepare for the punch in?

Back 1

1) find two gaps
2)make sure they're big enough to successfully execute the punch.
3)make note of the smpte addresses of those points.

Front 2

What do you do before executing the punch set up the MTR?

Back 2

1)place the MTR in ALL Sel Rep
2) Arm
3)locate the tape to the Pre Roll Start point

Front 3

How do you let the artist sing along w/ the old vocal before we punch him in?

Back 3

1) Ready Group
2) Ready Tape

Front 4

By pressing 1)none 2)TAPE 3)Group 4)Group+TAPE, what do we hear?

Back 4

Engineer:1)tape,2)Tape,3)Group,4)Group+Tape
artist:1)tape,2)Group+Tape,3)Group,4)Group+ tape

Front 5

Both the NEVE VR and SSL 6000 G Series are what type of consoles?

Back 5

IN - LINE monitoring consoles

Front 6

How are the following set up in Rec Mode:Channel input, Channel output, Monitor output
In SWAP

Back 6

1)mic, 2) Routing Matrix, 3) Stereo Bus
In SWAP: LF in the monitor path for mixing

Front 7

How in mix mode are the I/O set up. - Channel input, Channel Output, Monitor Output

Back 7

Line, Stereo Bus, Routing Matrix

Front 8

Channel input on both boards has three inputs
On monitor input...

Back 8

1)Mic, 2) Line, 3) group

1)channel output2)group output3)mtr return

Front 9

On the SSL, after the group trim the signal splits and goes to three places...

Back 9

1)Group Switch(Sub Gp)
2)Group out
3)Ready Group

Front 10

On the Neve, after the group trim the signal splits and goes to three places...

Back 10

1)Group Switch (Grp)
2)Group out
3)OD ( This does not work on the this NEVE)

Front 11

In Rec+Swap and (Mix) the small fader feeds...

Back 11

The routing matrix and the direct switch

Front 12

The DIrect signal bypasses what circuits on the SSL

Back 12

1)-/+ pan (if engaged)
2) routing matrix
3)group bus
4)group trim

Front 13

The DIrect signal bypasses what circuits on the NEVE

Back 13

1)-/+ pan (if engaged)
2) routing matrix
3)group bus

Front 14

Four places where the (TBP)wet signal can returned in the patchbay.

Back 14

1)Ch line ins:return wet sig.to any unused large faders normals to the st bus in Mix
2)Tape Mon. ins:"""small faders assign to stereo bus in the routing matrix
3)insert returns:ret. wet signal to eiter lg or sm faders on the NEVE or lg faders on the SSL
4)aux returns:returns wet signal to any of the four aux returns in the Master section which automatically feeds the stereo bus

Front 15

How it is set up! ON SSL AND ON THE NEVE

Back 15

Hit OUTPUT(SSL) or CH.OP (NEVE) on an I/O, 2.Select two unused buses in the routing matrix(-/+ pair)3. Patch from corresponding g/o to L/R input of a TBP.4PATCH OUT THE TBP to any 4 ret points.5 Bring ret. faders to unity gin and hard pan them.6 raise the small fader while listening to wet/dry ratio and observing meter on TBP.