• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/31

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

31 Cards in this Set

  • Front
  • Back
  • 3rd side (hint)
Bleed air is normally taken from the ___th stage (low pressure)
5th
------th stage of the compressor assists during low engine speeds
9th
9th stage (high pressure) valve is ____ ________ closed, open at ____, and closes at __ psi.
spring loaded
idle
35
The Engine Bleed Valve is __ controlled and uses ____ force to open, _____ force to close
DC
pneumatic
spring
Engine Bleed Valve acts as a ______ _______ and ____ ___ _____
Pressur Regulator
Shut-off Valve
Engine Bleed Valve gets electrical control from ____ __ and ____ __ busses
DC 1
DC 2
Engine Bleed Valve acts as a temperature regulator and closes at ____ F. The _____, _____, and ____ lights illuminate.
490F
BLEED TRIP OFF
AIR COND
MASTER CAUTION
The APU Bleed Switch/Valve is __V DC operated off the ____ Bus.
28 V
Battery
The APU Bleed Valve is able to open into the left duct when APU speed is > ___ RPM
95%
Max Pneumatic System Pressure
60 PSI
The ______ valve separates the Manifold into left and right sides
Isolation
The Isolation Valve is ___ operated and remains in position with a ____ _____.
AC
Power Failure
When in AUTO with either one or more packs or bleeds off, the isolation valve _____.
opens
The Isolation Valve looks at the bleed ______, not the bleed _____.
switches
valves
It is "switch sensitive"
The _____ bleed switch has no effect on isolation valve position
APU
Pneumatic Pressure Indicator requires ____ power.
AC
Wing Body Overheat
Left Side elements
Right Side elements
Left: engine strut, leading edge, air cond bay, keel beam, APU
Right: engine strut, leading edge, air cond bay
Electronic (Analog) Pressure Controller failure causes
1) Loss of AUTO AC pwr for more than 15 seconds
2) Cabin ALT 13, 875 ft
3) Excessive cabin rate of change +/- 1800 fpm
OFF SCHED DESCENT light causes
(Analog Pressure Controller)
1) A/C descent prior to cruise
-Controller programs cabin to land at takeoff field elevation
OUTFLOW VALVE switch
(Analog Pressure Controller)
OPEN- opens main cabin outflow valve electrically
CLOSE- closes main cabin outflow valve electrically when in manual mode:
full travel 7 sec in AC, 14 sec in DC
Digital Pressure Controller failure causes
1) loss of DC power
2) pressure controller fault/failure
3) excessive cabin rate of change +/- 2000 fpm
4) Cabin ALT > 15,800 ft
OFF SCHED DESCENT light causes
(Digital Pressure Controller)
1) A/C has started descent at least 1000 ft prior to cruise
-T/O alt is retained in memory and auto controller schedules descent for return to dept airport minus 300 ft
Main Outflow Valve is signalled closed if cabin alt exceeds ____ft in AUTO or ALT mode or ___ft in STBY mode.
14,500 ft - AUTO or ALT
14,625 ft - STBY mode
Flow Control Valve (300/500) is spring loaded open during ____ ____, ____ ___, and ____ ____ below a cabin diff press of approximately ___ psi
Ground Operation
Unpressurized Flight
Pressurized Flight, 2.5 psi
Discharges warm air from EE Bay. When valve closes, air is directed around fwd cargo compartment liner for in-flight heating.
Overboard Exhaust Valve OEV (700) 3 modes
Normal Mode
High Flow Mode
Smoke Clearance Flow Mode
Pneumatically controlled pressure regulated air shutoff valve
OEV Normal Mode
Fully closed when diff press is more than ___psi
1 psi
Exhaust air is then discharged under the fwd cargo compartment floor for inflight heating
OEV High Flow Mode occurs when (3 conditions)
1) Either pack in HIGH
2) Recirc Fan in AUTO
3) Main Outflow Valve has supplied "open enable" cmd
OEV Smoke Clearance Flow Mode occurs when (2 conditions)
1) Either pack in HIGH
2) Recirc Fan OFF
28 V DC actuator overrides pneumatic control to open OEV to clear smoke
Forward Outflow Valve (300/500) closes when Main Outflow Valve is within ___ of full-closed position or ___ ___ is operating.
0.5 degrees
recirc fan
Discharge exit for air circulated around the fwd cargo compartment
Forward Outflow Valve opens when the Main Outflow Valve opens approx ___, or if the ___ ___ is not operating.
4.5 degrees
recirc fan
Placing the right pack to HIGH turns off recirc fan and opens FOV, adding more fresh air to pressure vessel
Pressurization Relief Valves limit differential pressure to ___ psi in 300/500 or ___ psi in 700.
8.65 psi
9.1 psi
Vacuum relief valve prevents pressure inside a/c from becoming less than ambient pressure. Can be checked on walk-around by pushing door inward