Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
13 Cards in this Set
- Front
- Back
_____ is a method of pattern development used to develop patterns for irregular shaped objects |
Triangulation |
|
____is a short cut method of layout |
Rollation development |
|
The ___ of a pattern is the distance around the duct |
Stretch out |
|
The vertical lines that become the corners of the duct after it is folded in a band brake are called ____ |
Brake lines |
|
The ____ _____ requires no allowance to be added to the completed pattern |
Raw edge |
|
The slip cleat, sometimes called the S-cleat, is approximately ____ wide |
1” |
|
The drive clear is approximately _____ wide |
1 1/8” |
|
The slip and drive connection requires a ____ allowance to be added to the duct connection |
1/2” |
|
The standing drive connection is also called the ____ connection |
CP |
|
A hammerlock is also called the |
Tap in |
|
The _______ ______ is a hooked seam with a single offset |
Grooved seam |
|
Of all the machine formed locks, the _______ ______ is the most common used lock in the sheet metal trade |
Pittsburgh lock |
|
The duct notch, radius fitting notch and the transitional digging notch are all notches used when notching for the ______ duct connection |
Slip and drive |