Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
39 Cards in this Set
- Front
- Back
Liquid that flows easily, such as gasoline, has a _______ Viscosity? |
Low |
|
Hydraulic _______ eliminates the need for complicated system of gears, cams and levers? |
Fluid |
|
The main pump draws from the _______ or Low-pressure (LP) accumulators and charge the high-pressure (HP) accumulators or HP tank? |
???? |
|
If the pressure in the exhaust tank exceeds _____ pounds per square inch gauge (PSIG), the exhaust tank relief valve lifts to discharge air from the exhaust tank |
????? |
|
When the main pumps are ______, the filtered and cooled hydraulic fluid is returned to exhaust tank? |
????? |
|
Five physical factors that can affect its behavior. |
Gravity Atmosphere Specified force Inertia Friction |
|
Viscosity of flow |
The average speed at which the fluid moves past a given point |
|
Viscosity |
Measure of a fluids resistance to flow Low - lose High - thick |
|
Liquid viscosity is affected by |
Changes in temperatures and pressure |
|
Friction tends to oppose? |
Motion |
|
Hydraulic on moving parts enables them to? |
Move more freely |
|
Factor that impact chemical stability (Oil molecule) |
Metal particles Heat Oxygen Water |
|
Factor that impact chemical stability (increasing total acid number TAN) |
Acid Corrosion |
|
Flashpoint |
The temperature at which a liquid gives off vapors in sufficient quantity to ignite momentarily or flash when a flame is applied |
|
Fire Point |
Temperatures that a distance gives off vapors in sufficient quantity to ignite and continue to burn |
|
Flashpoint minimum temperature vary from _______ degrees for lightest oils to _______ degree for the heaviest oils. |
300 510 |
|
Four type of hydraulic fluid |
Petroleum Synthetic fire resistant Water base Synthetic hydrocarbon |
|
Petroleum-based fluids |
Most common used in ships systems |
|
Synthetic fire resistant fluids |
MIL-H-19457 Used where fire resistant is required |
|
Which hydraulic fluids are considered hazardous material? |
All hydraulic fluids are considered hazardous. |
|
Information regarding hydraulic fluid refer to? |
NSTM Chapter 670, volume 2 HMUG Group 12 |
|
Hydraulics provide the motive for ________? |
ACE Platform |
|
The main pumps and servo pumps continue to operate until the accumulators and the servo control accumulator are? |
Fully recharged |
|
Once recharged the main pumps will then _______ until next demand is initiated. |
Go off-stroke |
|
In emergency situations what can be used to raise and unload platform or circulate hydraulic fluid through exchanger? |
Sump pumps |
|
Belleville spring reseats itself when pressure drops below? |
90 PSIG Amphibious HP point is 150 PSIG Valve reseat at 135 |
|
When the differential pressure exceeds _______ the piston is pushed away from the indicator button decreasing the magnetic pull. |
90 PSID (CVN have the pop up indicators) |
|
Exhaust tanks are designed for use at approximately________PSIG? |
200 |
|
Exhaust tanks on CVN 73 capacity |
2,500 gallons |
|
How many sight gauges, pressure gauges, fluid flow switches Exhaust tank have |
Two |
|
Circulation pump and filter assembly |
Pumps hydraulic fluid from exhaust tank through the heat exchanger |
|
Circulation pump and filter assembly consists of? |
AC Motor Coupling Hydraulic pump Relief Valve Suction strainer Filter Temperatures switch and other valves |
|
CVN circulation pump is _______? LHA/LHD circulation pump is____? |
CVN double cartridge Amphib is piston pump |
|
Circulation pump relief valve prevent the pressure in the discharge from exceeding |
285 PSIG |
|
How many main pumps are there onboard LHA/LHD? |
Four ( might be 8) |
|
Regulates pressure in main pump to? |
3,300 PSIG |
|
Servo tank assembly is the supply tank for? |
Hydraulic motor |
|
CVN ACE has how many lift cables? |
20 (8 forward and 12 aft) |
|
Motor operated valves |
6” and 10” Four per ACE on CVN 73 Three per ACE on LHA /LHD 5” and 8” |