Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
18 Cards in this Set
- Front
- Back
Photovoltaics rely on unique properties of _____ to convert solar radiation directly into electricity |
Semiconductors |
|
What factor would typically limit the power output of a photovoltaic array that could be installed on a residential rooftop area? |
Area |
|
The energy product of photovoltaic modules and arrays overtime is primarily determined by _____ |
Irradiation |
|
What is the average solar irradiation on a surface that receives a 4 kilowatt hour per square meter over a 10 hour period |
400 W/m² |
|
The peak solar irradiation incident outside the earth's atmosphere is approximately ____ times the nominal peak terrestrial irradiation at sea level |
1.3 |
|
A horizontal surface generally receive the max amount of solar radiation during?? |
Summer |
|
A pyranometer is used to measure ____ and _____ solar radiation |
Diffuse and direct |
|
Shading analysis is a typical test conducted during a?? |
Site survey |
|
Large obstruction towards the south side and a present the greatest overall shading effect on a?? |
Photovoltaic array |
|
A ____ photovoltaic system operates autonomously |
Stand alone |
|
Balance of system components consist of wiring, disconnects, switchgear,overcurrent protection, conduit systems and mounting supplies |
Know all |
|
___ is the process typically used for applying n-type semiconductors material to n-type silicon wafer |
Gas diffusion |
|
In the figure below, A is a short circuit amperage, B is the max current Point, C is the max voltage point, D is open circuit voltage point in it is a maximum power point |
|
|
Photovoltaic modules are connected in parallel to build ____ and _____ output |
Current , power |
|
A unique feature of alternating current photovoltaic modules is |
That no Field installable DC wiring is present 690.2 & 690.6(A) |
|
What is the primary distinction between interactive inverters and rotating generators |
Rotating generators can act as loads while inverters cannot |
|
IEEE 1547 installations standards apply to photovoltaic and other generators less then ____ |
10 megawatts |
|
If a 120V inverter output is placed between one ungrounded conductor and the neutral of a 240V system, what is the result? |
It adds to the load connected between the neutral and any one ungrounded conductor 705.95(A) |