Reading...
Play button
Play button
Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
12 Cards in this Set
- Front
- Back
|
What materials can be used in SLS?
|
Polymers, ceramics and metals
|
|
|
Describe the SLS process (8 steps)
|
1. Build chamber or platform is heated
2. Slice files fed to CO2 laser 3. Fine layer of powder applied to the platform/last layer 4. Laser scans slice file onto the top layer of powder 5. Powder partially fuses to adjacent particles and layer below 6. Repeat 3-5 for each layer 7. Unused powder removed and recycled 8. Post Processing |
|
|
How is the SLS system designed to improve the part quality?
|
Powder is supplied from either side of the platform, preventing powder from building up due to part structure.
Counter-rotating roller levels and compacts the powder Construction takes place in a controlled atmosphere. |
|
|
What are the advantages of SLS?
|
Powders are easy to produce
Close to virgin material properties No supports Safer than SLA Suitable for functional testing Efficient recycling Can produce multiple parts in z direction Little post processing |
|
|
What are the limitations of SLS?
|
Part can be distorted by heat
More energy than SLA (10000x) Cooling can induce stresses Dust and particles must be contained and controlled. Can create trapped pockets of powder. |
|
|
How are SLS parts post processed?
|
Must be carefully and evenly cooled to prevent warping. Part is removed from powder cake by brushing or air blowing. Some excess powder is recycled.
|
|
|
Describe temperature control in SLS
|
Important, especially for crystalline polymers. Chamber is heated to 10/20 degrees below melting point of the powder, so relatively little energy comes from the laser. When cooling the part, temperature must decrease at a controlled rate, as rapid cooling can cause warping, reduced crystallisation, and unpredicted physical properties. Cooling too quickly reduces the recycleable powder. The edge of the powder cake can cool faster than the middle, causing distortion to the part.
|
|
|
What is the main difference between SLS systems offered by 3D Systems and EOS?
|
3D Systems machines can use all their materials, EOS had different ranges for Polymer and Sand
|
|
|
Describe the Duraform polymer used in 3D Systems' SLS products
|
The most common type of polymer used, Duraform is made of polyamide 12, a heat and chemical resistant material. The material is made of fine particles, allowing for higher resolution. When the part is finished, it is cooled from 173 to room temperature over a number of hours.
|
|
|
Describe the Sandform Zr2 sand used in 3D Systems' SLS products
|
Consists of a polymer, coated with Zirconium. Grain size varies from 35-210 microns. Used to produce sand castings.
|
|
|
What are the advantages of SLS compared with SLA?
|
Supports aren't required, reducing material costs. Properties are more stable over time. Acheives a more consistent finish.
|
|
|
What are the advantages of SLA compared with SLS?
|
Commecialised much earlier, so more experience. Higher accuracy and resolution. Smoother finish. Lower energy consumption.
|
