P-3 Natops Closed Book Questions

Front 1

If cabin altitude exceeds ____ feet after a pressurization loss, the flight stations crewmembers shall don oxygen masks and notify all personnel to do the same.

Back 1

10,000

Front 2

What stations dons harness and helmet with visor down and jettisons all classified material?

Back 2

Station 8

Front 3

What are the indications of a rack overheat on the ground?

Back 3

The rack overheat lights will illuminate and a pulsing aural warning horn will sound in the nose wheel well and in the cabin.

Front 4

During emergencies, if LPU is worn, crewmembers _____ turn on personal flashlights on survival vests in preparation for possible power loss.

Back 4

Should

Front 5

What action is to be taken immediately if a cabin observer window cracks in flight?

Back 5

Immediately evacuate personnel.

Front 6

In the event of _____, one long ring on the command bell shall be followed by an ICS PA override alert.

Back 6

An Immediate Ditch.

Front 7

How is the intention to ditch passed?

Back 7

Announced over ICS PA Systems

Front 8

For the PRC-149 the operator should first acquire ______ prior to transmitting on the triple frequency beacon mode or the 406 beacon mode.

Back 8

the satellites in GPS mode.

Front 9

The crewmember specifically listed to check the HF-2 coupler during a fire of unknown origin is:

Back 9

Crew Station 7

Front 10

During an APU fire, if the exhaust door fails to close, the HRD extinguisher agent will discharge ____ seconds after the fire warning.

Back 10

20

Front 11

What is the first step in smoke and fume elimination procedures?

Back 11

Cabin Exhaust Fan to "ON"

Front 12

During smoke and fume elimination procedures, the order in which the hatches are opened is (assuming the aircraft is slower than 170 knots):

Back 12

Freefall chute,
Smoke Removal door,
Starboard Emergency Exit.

Front 13

What track(s) of the AQH-4(V)2 record signals which are used to govern tape speed during replay?

Back 13

Tracks 7, 8, 23, and 24.

Front 14

What antenna is responsible for the reception of Active uplink?

Back 14

Starboard ACPA Antenna.

Front 15

What will be lost if the fuse on the Sono Interconnection box is blown?

Back 15

Sono Audio and ICS Audio

Front 16

What are the two primary components of the Acoustic Distribution Sytem?

Back 16

ADB's and SONO Audio Selectors.

Front 17

What does SASP stand for?

Back 17

Single Advanced Signal Processor.

Front 18

A Single DTF-1 Tape will record approximately ____ hours of data.

Back 18

4

Front 19

With the ATSG RF output level set to 2, the signal is attenuated _____DB.

Back 19

24

Front 20

When selecting the APU control switch from ON to OFF, the APU will shut down and the exhaust door will close after approximately a ____ minute time delay.

Back 20

1

Front 21

What will cause the APU to automatically shut down?

Back 21

Loss of APU oil pressure
An APU compartment fire.
Overspeed in excess of 106%

Front 22

The maxiumum normal RPM for the APU Is _____% on the ground.

Back 22

98-102

Front 23

An overspeed of 106% will cause an automatic shutdown of the APU. IAW NATOPS, what other condition will automatically shut down the APU?

Back 23

Loss of APU oil pressure

Front 24

What is disabled when teh APU Fire Extinguisher safety switch is actuated?

Back 24

The APU Starter, if the APU is running, it shuts down.
Fire extinguishing system is deactivated.
Intake and Exhaust Doors cannot be moved.

Front 25

During a Condition IV inspection, it is noted that the hydraulic pump on the starboard side of the hydraulic service center is leaking fluid. How should this be reported to the FE and Pilot?

Back 25

Hydraulic Pump 2 is leaking fluid.

Front 26

During external inspection you check the air multiplier oil level and find it at the 1/2 mark on the sight gage. The air multiplier should be _______.

Back 26

Serviced before using.

Front 27

What will occur with the APU inflight arming switch in the Arm position while on the deck?

Back 27

Air Conditioning and Engine starting are not available.

Front 28

To prevent corruption of the ADR Hard Drive after a cold start, power must be removed until AOP load have been completed (T/F).

Back 28

True

Front 29

What does the Tactical Symbology "Y" Represent?

Back 29

Record Only

Front 30

The USQ-78B Tech Refresh Acoustic Processing Suite (APS) Active processing control function group initiates the processing, display, and control of sensor data from up to ___ DICASS sonobuoys.

Back 30

32

Front 31

If SASP was loaded prior to the TMS, it is highly recommended that the operator perform a ____ after the Tactical Computer is loaded, to ensure the station is correctly interfaced with the TMS.

Back 31

Hot Start

Front 32

The four kinds of alerts displayed at SS1/2 station are:

Back 32

Procedural, Operational, System and PPU.

Front 33

The minimum simultaneous contact conditions for initating LOC track are:

Back 33

1 DIFAR and 1 LOFAR, or 2 DIFARs or 3 LOFARs

Front 34

The PPU cycle is the periodic rate at which teh PPU processes the __ data received from the AU.

Back 34

LTI

Front 35

When threat lines or center frequency is used, the frequency window around each source allow for a doppler shift that would relate to a target speed of ___ knots?

Back 35

29

Front 36

The "ACTV TAB" switch provides the functionality to display active bearing, doppler and ___ data in a tableau for the sensor operator's reference and the HSP.

Back 36

Range

Front 37

Linear ALI scaling is operationally useful in ____.

Back 37

Distinguishing between narrowband lines and background noise.

Front 38

Short detection ranges may prohibit the use of the target tracker function, but ____ functions can be used to provide the crew with almost real time doppler and bearing data.

Back 38

LOC line/bearing

Front 39

How many consecutive monitoring cycles does a noisy RF with a VHF level of 0 can be cleared from the Noisy RF tableau?

Back 39

2