Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
14 Cards in this Set
- Front
- Back
What are special built tools that are necessary for the insertion of the replacement waster sleeves and welding of replacement strainer bars?
|
The cross brace jig, welding stage, and the watering/dewatering apparatus
|
|
When cutting the 2 middle strainer bars from the sea chest wall how many inches out from the sea chest must you cut it?
|
2" from the strainer wall
|
|
At what positions should you install 2, 6 ft. all-threads to remove the strainer grate?
|
opposing sides of the grate, at the 12 and 6 o'clock position
|
|
What minimum clearance must the grate be lowered from the sea chest opening?
|
4 ft.
|
|
A replacement waster sleeve section, that will recieve the steam blow-out hole, should be at which of the 2 sections?
|
Sections with the 15 degree off-center cuts on the leading edges
|
|
If pitting in the sea chest groove or shoulder area has been cleaned to bare metal, what should it be painted with?
|
MIL-P-23236 TYPE III, Class 1 paint
|
|
Where is weld repair not recommended?
|
In the sea chest groove or shoulder area
|
|
Pitted, corroded, eroded, and damaged areas below the groove or shoulder with a depth exceeding ______ % of the wall thickness shall be restored with weld buildup?
|
25%
|
|
What is the anti-rotation dowel made from?
|
brass dowel
|
|
the anti-rotational dowel should protrude a maximum of ___/___ inch from the bottom of the groove?
|
5/16 inch from the bottom of the groove
|
|
What should you use to dry the sea chest walls to permit paint adhesion?
|
acetone
|
|
When painting a sea chest what is the maximum thickness of the coat?
|
20 mils in thickness
|
|
What is used to form a gasket between the waster sleeve flange and the sea chest valve flange?
|
polysulfide rubber adhesive
|
|
What is the minimum cure time for the polysulfide rubber adhesive?
|
30 minutes
|