• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/16

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

16 Cards in this Set

  • Front
  • Back






"___________ or __ ______ _________ _________ cable must never be used inside the customer premise?
messsengered or PE jacketed underground flooded (BRIS 8.1.5)
"To prevent water damage, how must all exterior entry holes must be drilled?
drilled so that the outside of the hole is slightly lower than the hole on the inside of the wall. (BRIS 8.4.1)
"Jumpers between the wall plate and the CPE should not be more than how many feet long?
6' (BRIS 8.5.2)
"Drop cable routed through a basement perpendicularly to the floor/ceiling joists must be routed through holes drilled at least ______ from the bottom of the joist.
2-inches (BRIS 8.5.7)
"Drilling through the ______ _________ of any floor/ceiling solid wood joist span will weaken the solid wood joist and is PROHIBITED.
middle one-third (BRIS 8.5.8)
"Drop cable routed perpendicularly to any floor/ceiling joists in basements must _____ be routed through joist holes occupied by any other __________ _____.
NEVER, Electrical wires (BRIS 8.5.11)
"In an ariel installation, the length of a trap/filter must not exceed the length of what? And if that length is exceeded what must be used between the tap port and trap/filter?
locking terminator / Jumper cable (BRIS 3.4.2)
"In underground installations, where should the trap/filter be attached?
the feeder cable, pedestal stake or to a trap holder bracket. (BRIS 3.4.6)
"Cables used for ariel installations must have what?
A non flowing flooding compound on the braid wires. (BRIS 4.1.3)
"What must never be placed over the lashing wire?
Span clamps (BRIS 4.2.1.4)
"Designed for dead-ending messengered drop cable, What should be used for attaching drops in all new ariel drop installations ?
Approved drop clamps (BRIS 4.2.1.1)
"When would you be allowed to connect a ariel service drop to the power mast?
NEVER (BRIS 4.2.5.2)
"Ariel service drops must NEVER be attached to what?
TV antennas, chimneys, lighting rods, or gutters