Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
23 Cards in this Set
- Front
- Back
What is Copper Beryllium? Name two components containing it.
|
Cancer causing agent (Lock pin pullers + Droop Stops)
|
|
What is the primary warning about Copper Beryllium?
|
Never grind or sand.
**Also never inhale as a dust or splinter in the skin. |
|
What are two uses for flat coatings on the aircraft?
|
1 - Protect the aircraft from corrosion
2 - reduce glare/visual detection |
|
For effective helicopter corrosion prevention, __________ ________ __________ shall be done daily after the last flight.
|
fresh water rinse
|
|
How often does the MRC-350 dictate the aircraft be washed?
|
7 days at sea
14 days on shore |
|
What are the two specific areas that must be paid attention to during a corrosion inspection?
|
Gearboxes and Avionics
|
|
When washing the aircraft, start from _______ to _______, and _________ to _________ to prevent streaking
|
Tail to nose, bottom to top
|
|
What is the purpose of emergency reclamation?
|
To reclaim salvageable components and remove them by priority.
|
|
The ________ ________ _______ ________ are installed between the hub and spindles to restrain hunting of the main rotor blades.
|
Main Rotor Head Dampers
|
|
Each damper is filled with ______ _______.
|
Hydraulic fluid
|
|
Pressurizing the dampers positions the blades ______ ______ to allow for blade folding.
|
Full Forward
|
|
What are the two methods by which the tail wheel lockpin can be locked and unlocked?
|
Electrically and Manually
|
|
What are the four factors that affect helicopter flight?
|
Lift, Weight, Drag, and Thrust
|
|
What are the four factors that affect helicopter performance?
|
Weight, Weather, Wind and Engine performance
|
|
What are the six sections of the fuselage
|
Cockpit, Cabin, Main Rotor Head, Transition, Tail Cone, Tail Pylon
|
|
What does BIM stand for?
|
Blade Indicator Method
|
|
How can you tell that a BIM is not within limits?
|
The three black bands will show without holding pressure in the spar.
|
|
What are the three flight controls that affect helicopter flight, and their effects?
|
Collective stick - Pitch (lateral axis) of all four main rotor blades
Cyclic stick - Pitch and roll of the a/c Rudder Pedals - Pitch of the tail rotor blades and control a/c heading (yaw) |
|
What is the purpose of the Wire Strike Protection System?
|
To protect the helicopter in case the airframe comes in contact with wires in its path of flight
|
|
How many 'Cutters' (Wire Strike) are on the MH-60S?
|
4, Hydraulics bay cover, one on each main landing gear, and one at the aft end of the Hyd. bay access cover.
|
|
How many 'Deflectors' (Wire Strike) are on the MH-60S?
|
12
|
|
The tail wheel is capable of spinning _______ degrees to aid in turning helicopter while taxiing.
|
360
|
|
Access and inspection openings are identified by a three digit number 1.2.3 . Define what each stand for.
|
1 - Work Area
2 - Side (1=left, 2=right, 0=center) 3 - Panel Number |