Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
28 Cards in this Set
- Front
- Back
3 Important steps during Low Level Entry/Exit:
(Capt. Bohn) |
Hack
Squawk Talk |
|
After exiting route run the following checklist:
(Capt. Bohn) |
Climb
Cruise (>15 min) ATIS/TOLD/Crew Brief Descent Check |
|
Avoid Airports by ___ AGL or ___
(AP1-B) |
Avoid Airports by 1500ft AGL or 3NM
|
|
You must have ___ to Enter/Exit IR routes
(AP1-B) |
You must have ATC clearance to Enter/Exit IR routes
|
|
What is the Wx requirements for IR routes?
(AP1-B) |
1500ft from clouds
3mi visibility |
|
What do you Squawk on IR routes?
(AP1-B) |
Squawk ATC assigned code
|
|
What is the Wx requirements for VR routes?
(AP1-B) |
3000ft and 5mi
|
|
When on Low Level routes monitor ___.
|
255.4
(Ch 17 LAFB) |
|
On VR routes Squawk?
(AP1-B) |
4000 unless assigned otherwise
|
|
Is an SR route a MTR? What altitudes are SR flown?
(AP1-B) |
SR are locally owned non-MTR's, flown at or below 1500ft AGL
|
|
T/F: SR routes are displayed on sectionals and Jeppesen charts.
(AP1-B) |
False
|
|
When flying a SR route who is responsible for deconfliction?
(AP1-B) |
Scheduling a SR does not ensure deconfliction. FSS is not notified so deconfliction rests on the pilot.
|
|
What is the max AS on SR routes?
(AP1-B) |
250KIAS or less
|
|
While on SR routes monitor ___.
(AP1-B) |
255.4
(CH 17 LAFB) |
|
Squawk ___ unless assigned, while on SR routes.
(AP1-B) |
1200 (VFR)
|
|
For locally published routes, slow routes (SR), and instrument routes (IR), aircrew will ensure a ceiling and visibility of at least ___ft and ___miles and ___ft and ___miles for visual route (VR).
(11-2T-1) |
1500 and 3 on SR/IR
3000 and 5 on VR |
|
Maximum planned groundspeed on military training routes (MTR [IR/VR]) is ___knots. (normal planned groundspeeds are ___ to ___ knots)
(11-2T-1) |
270knots GS on IR/VR (MTR's)
210-240knots GS planned |
|
Low Level routes will be flown between ___ and ___ft AGL.
(11-2T-1) |
500
1500 |
|
The minimum allowable on all low levels is ___ft above the highest terrain within ___ft of the aircraft.
(11-2T-1) |
500
2000 |
|
Plan to fly a minimum of ___ft above the highest obstacle within __NM of the aircraft.
Once the obstacle is acquired visually and positively identified, fly a minimum of ___ft above the highest obstacle within ___ft of the aircraft. (11-2T-1) |
500ft within 2nm
500ft within 2000ft |
|
Enter the route no earlier than ___ minutes after ___ (___ hour for mountainous terrain) and exit the route no later than ___ minutes prior to ___ (___ hour for mountainous terrain).
(11-2T-1) |
30 minutes after to sunrise (1 hour mnt.)
30 minutes after sunset (1 hour mnt.) |
|
IR/VR MTRs that include one or more segments
above ___ shall be identified by ___ characters, (for example IR-___ or VR-___) (AP/1B) |
IR/VR MTRs that include one or more segments
above 1500 feet AGL shall be identified by three number characters, (for example IR-XXX or VR-XXX) |
|
The FAA has issued a speed authorization to DoD to permit aircraft to exceed ___knots IAS (below ___ MSL) within the ___ and ___ confines of published IR/VR MTRs.
(AP/1B) |
The FAA has issued a speed authorization to DoD to permit aircraft to exceed 250 knots IAS (below 10,000 MSL) within the lateral and vertical confines of published IR/VR MTRs.
|
|
All IR/VR MTRs are displayed on ___, ___ and ___ (IR routes 1500 feet and above should be charted on Enroute Low and Area Charts).
(AP1/B) |
All IR/VR MTRs are displayed on VFR Sectionals, VFR Terminal Area Charts and Area Planning AP/1B Military Training Route Charts (IR routes 1500 feet and above should be charted on Enroute Low and Area Charts).
|
|
ERAA is computed to provide ___ft (___ ft "mountainous" [FLIP]) clearance above the highest obstacle within ___NM of either side of the route.
(11-247) |
1000ft
2000ft Mountainous 25NM of either side of the route |
|
Obtain a current ___ setting within ___ of entering the route.
(11-247) |
Altimeter
1hr |
|
Set the radio altimeter warning to ___. Set the DH on your EHSI to an altitude ___ below the planned terrain clearance altitude.
(11-247) |
500 to 1500ft (terrain clearance altitude)
10% |
|
Complete the LL entry checklist. Set the ___ in the ___. Post an ___ for route abort procedures.
(11-247) |
Complete the LL entry checklist. Set the ERAA in the altimeter altitude preselect window. Post an MCT for route abort procedures.
|