Reading...
Play button
Play button
Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
10 Cards in this Set
- Front
- Back
|
In a LAN, which of the following terms best equates to the term VLAN?
a. Collision domain b. Broadcast domain c. Subnet domain d. Single switch e. Trunk |
Broadcast domain
|
|
|
Imagine a switch with three configured VLANs. How many IP subnets are required, assuming that all hosts in all VLANs want to use TCP/IP?
a. 0 b. 1 c. 2 d. 3 e. You can't tell from the information provided. |
3
|
|
|
Which of the following fully encapsulates the original Ethernet frame in a trunking header rather than inserting another header inside the original Ethernet header?
a. VTP b. ISL c. 802.1Q d. Both ISL and 802.1Q e. None of the answers are correct. |
ISL
|
|
|
Which of the following adds the trunking header for all VLANs except one?
a. VTP b. ISL c. 802.1Q d. Both ISL and 802.1Q e. None of the other answers are correct. |
802.1Q
|
|
|
Which of the following VTP motdes allows VLANs to be configured on a switch?
a. Client b. Server c. Transparent d. Dynamic e. None of the other answers are correct. |
Server, Transparent
|
|
|
Imagine that you are told that switch 1 is configured with the auto parameter for trunking on its Fa0/5 interface, which is connected to switch 2. You have to configure switch 2. Which of the following settings for trunking could allow trunking to work?
a. Trunking turned on b. Auto c. Desirable d. Access e. None of the other answers are correct. |
Trunking turned on, Desirable
|
|
|
A switch has just arrived from Cisco. The switch has never been configured with any VLANs, VTP configuration, or any other configuration. An engineer gets into configuration mode and issues the "vlan 22" command, followed by the "name Hannahs-VLAN" command. Which of the following are true?
a. VLAN 22 is listed in the output of the "show vlan brief" command. b. VLAN 22 is listed in the output of the "show running-config" command. c. VLAN 22 is not created by this process. d. VLAN 22 does not exist in that switch until at least one interface is assigned to that VLAN. |
VLAN 22 is listed in the ouput of the "show vlan brief" command.
|
|
|
Which of the following commands list the operational state of interface Gigabit 0/1 in regard to VLAN trunking?
a. show interfaces gi0/1 b. show interfaces gi0/1 switchport c. show interfaces gi0/1 trunk d. show trunks |
show interfaces gi0/1 switchport, show interfaces g0/1 trunk
|
|
|
An engineer has just installed four new 2960 switches and connected the switches to each other using crossover cables. All the interfaces are in an "up and up" state. The engineer configures each switch with the VTP domain name Fred and leaves all four switches in VTP server mode. The engineer adds VLAN 33 at 9AM and then within 30 seconds, issues a "show vlan brief" command on the other three switches, but does not find VLAN 33 on the other three switches. What answer gives the most likely reason for the cause of the problem?
a. VTP requires that all switches have the same VTP password. b. The engineer should have been more patient and waited for SW1 to send its next periodic VTP update. c. None of the links between the switches trunk because of the default 2960 trunking administrative mode of auto. d. None of the other answers are correct. |
None of the links between the switches trunk because of the default 2960 trunking administrative mode of auto.
|
|
|
Switches SW1 and SW2 connect through an operational trunk. The engineer wants to use VTP to communicate VLAN configuration changes. The engineer configures a new VLAN on SW1, VLAN 44, but SW2 does not learn about the new VLAN. Which of the following configuration settings on SW1 and SW2 would not be a potential root cause why SW2 does not learn about VLAN 44?
a. VTP domain names of larry and LARRY, respectively b. VTP passwords of bob and BOB, respectively c. VTP pruning enables and disabled, respectively d. VTP modes of server and client, respectively |
VTP pruning enables and disabled, VTP modes of server and client
|
