Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
15 Cards in this Set
- Front
- Back
|
what are the 5 indicator lights on the display for |
on, Flow, Total water, %, Total foam |
|
|
how many buttons are on the face of the foam pro? What do they do?
|
4, LU foam/on, RU select function, LL decrease foam, LR Increase foam
|
|
|
what does hi flo indicate
|
more water/gpm is been delivered than the capacity of the foam pump can keep up with
|
|
|
lo flo
|
the injection rate required is lower than the pump can deliver/ flowing too little water/gpm |
|
|
lo con
|
low foam tank level |
|
|
No con
|
after 2 consecutive minutes of Lo con and the tank is empty
|
|
|
how long will the pump run on an empt No Con" tank"
|
2 minutes then will auto shut off and the display will go into stanby |
|
|
how do you reset the values after a pump
|
by pressing the two lower buttons at the same time and holding
|
|
|
what does ERR.EL indicate on the display
|
pump has stalled for 10 seconds or more or that motor will not run. |
|
|
how do you enter the simulated flow mode
|
by pressing both lower buttons at the same time until three lines are displayed
|
|
|
how is calibration mode activated
|
by removing the small allen screw on the face of the display on the left side and depressing the switch inside twice until it reads elec setup"" |
|
|
what is the relief valve set at
|
400psi |
|
|
how many amps does the the unit require
|
40 amps
|
|
|
how do you enter diagnostic mode
|
by removing the small allen screw on the right side of the face and press the switch inside
|
|
|
what kind of oil does the foam pump require
|
30 wt non detergent |
