Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
9 Cards in this Set
- Front
- Back
What is the rationale for making a custom tray?
|
-Impression tray with uniform relief form impression material will rsult in a much more accurate final impression (important in FPD construction). Uses less impression material due ot more close "fit" of tray to teeth (2-3 mm) and saves money; tray is more rigid
|
|
What are you looking for when you inspect VPS impression for a FPD?
|
-Must have recorded both preps, the edentulous ridge, and all teeth in the arch
-Margins should be evident on both preps, circumferentially around preps -Must have recorded unprepared root structure apical to margins |
|
What is the purpose for making interocclusal records?
|
-Allow opposing casts to be articulated accurately at some pre-determined position (CO or MI)
|
|
Material selection depends on locaiton of abutment teeth, If occlusion is table you can hand-articulate the casts (T/F)
|
-Only first statement is correct
-Only second statement is correct -Both statement is correct but not related -Both statement is correct and related ******** -Both statement are incorrect, but related |
|
How high should the working cast be trimmed form the base?
|
10-12 mm from the gingival crest to base
|
|
What are the clinical considerations for taking the impression for FPD?
|
-MUST manage the saliva, hemorrhage, tongue, cheeks, patients
-Do not let dry field become contaminated with saliva, hemorrhage -Do not let tongue/cheek contact preps while impression -Get an assistant |
|
IF there is a terminal FPD, you need a rigid recording material (T/F)
|
True: wax is not dimensionally stable to ship)
|
|
What are the materials you can use to make the interocclusal records for FPDs?
|
-ZOE paste is accurate but very rigid (fracture easily)
-PMMA resin (GC pattern resin) is accurate, rigid, hard to manage -Regisil (flowable VPS), not accurate fitting with opposing cast from alginate impression |
|
Describe the technique in Custom Tray Fabrication?
|
-Draw extend of tray extension on DX cast
-Block out any ST undercuts -Adapat 2 thickness of soft pink base palate (2-3) and 3-occlusal stops -Plan vaseline -Adapt Triads Tru-Tray into occlusal stop and over cast -Cure the triad with water -Trim sharp edges -Try in patient to determine accuracy and border extensions -Paint intaglio surface of tray -Make sure tray sites on tissue distal to terminal molars and paint 2-3 mm on external border tray |