Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
9 Cards in this Set
- Front
- Back
When using basic semi-precision layout practaces,. All measurements for any location must be taken from: |
A reference line or finished edge |
|
What are parallels used for |
Support and raise the workpiece |
|
What type of stock can you not use a center head to lay out the center? |
Hexagonal stock |
|
A surface gauge is what kind of layout tool |
Semi precision |
|
How wide do the dividers need to be to lay out a 3 inch diameter? |
1.5 inches |
|
What tool is used to layout a radius that is beyond the ability of your dividers |
Trammel |
|
What do you do after laying out the circumference of the hole |
Prick punch witness marks on the line |
|
Each vernier scale graduation on a 50 division metric vernier height gauge is equal to what |
0.02 mm |
|
What part of the scriber on a vernier height gauge should you regrind when dull |
The slanted surface (often but not always on top) |