Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
10 Cards in this Set
- Front
- Back
|
In a weld that requires more then one pass u can not use more than one process. True or false? |
False |
|
|
What degrees is a bevel edge usually cut at? |
30 degrees |
|
|
How far are your plates aloowed to be spaced apart? |
1/8-5/32 of a inch |
|
|
what should u offset your 2G plates when u tack them? |
3-4 degrees |
|
|
What are two advantages of using more then one process to complete a weld? |
to maximize joint economy and to increase weld deposition |
|
|
What mode of metal transfer is used in FCAW? |
spray |
|
|
What mode of metal transfer is used with MCAW in the 3g position |
short circuit |
|
|
electrode type is selected to match what? |
the chemical and physical properties of the base metal |
|
|
What type of cleaning is required before GMAW welding? |
grind or wire wheel to clean and weld before proceeding.
|
|
|
What are three things that affect gas flow? |
position, joint type, process |
