Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
30 Cards in this Set
- Front
- Back
|
Flight ready length |
57 Ft. 11 in. |
|
|
Flight Ready Height / Width |
22 Ft. 1 in. / Width 84 Ft. 8 in. |
|
|
Tie down provisions consist of how many fuselage fittings and where? |
6Two Fwd, Two Center, Two Aft and Two tow/tie down rings 6Two Fwd, Two Center, Two Aft and Two tow/tie down rings |
|
|
What is the aircraft mainly constructed of? |
Graphite-epoxy and fiberglass composite materials |
|
|
What is the total span of one proprotor? |
38Ft |
|
|
Where is the main cabin door located? |
In the proprotor tip path plane when in airplane mode. |
|
|
Describe Flaperons |
4Operate as ailerons and control roll axis during VTOL max 73° 4Operate as ailerons and control roll axis during VTOL max 73°While set as flaps max 47° While set as flaps max 47° |
|
|
Rudders |
Left rudder hyd system #1 Right rudder hyd system #2 Controls yaw axis |
|
|
Elevator |
3 piston actuators power single elevator. Controls pitch axis |
|
|
VTOL |
Vertical takeoff/ landing |
|
|
VTOL Flight |
Flight operations with nacelles between 85 degrees and the aft stop 96 degrees |
|
|
CONV |
Conversion |
|
|
CONV Flight |
Flight operations between 1 and 84 degrees |
|
|
APLN |
Airplane |
|
|
APLN Flight |
Flight operations with the nacelles on the down stops 0 degrees |
|
|
Wheel Assemblies |
The A/C has six tire and wheel assemblies |
|
|
Brakes |
carbon disk #3 hyd system 5,000 psi |
|
|
NLG |
Nose Landing Gear |
|
|
NLG |
nose wheel steering system is powered by the #3 hyd system. Operated by hyd drag strut /retraction actuators supplied by the 5,000 psi #3 system |
|
|
Pumps |
Hyd power is provided by three independent 5,000 psi system |
|
|
Swashplate Actuator |
There is 6 |
|
|
Authorized hyd fluid for reserivoirs |
MIL- PRF-8328 Primary MIL-PRF-5606 Alternate |
|
|
Type/Model/Series |
AE1107C-Liberty turboshaft engines X2 6150 shaft horse-power each interconnect shafting |
|
|
EAPS |
Engine Air Particle Separator |
|
|
Components of The Engine |
Torque Meter Compressor Section Accessory Drive Gearbox Power Turbine Assembly Gas Generator Turbine |
|
|
APU |
Auxiliary Power Unit |
|
|
MWGB |
Midwing Gearbox |
|
|
How Much fuel does the APU burn |
300 LBS per Hour |
|
|
Proprotor Systems |
lift and trust provided by a left and right counter-rotating proprotor system. Powered by the engines through the proprotor gearbox. each system consists of the hub, blade, pendulum damper, spinner, and swashplate. |
|
|
Proprotor Blade |
Constructed primarily of composite materials. |
