Reading...
Play button
Play button
Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
13 Cards in this Set
- Front
- Back
|
Yes or No:
Is a text mode upgrade supported when upgrading from VMware ESX 3.5 to VMware ESX 4.0? |
No
|
|
|
Which Product will provide automatic patching of VMware ESX 3.5 hosts?
|
VMTS Patch Manager
|
|
|
Name the upgrade steps for any upgrade to vCenter 4 and ESX 4
|
Upgrade Virtual Center
Upgrade ESX Upgrade VMware tools and VM hardware. |
|
|
What must you do to your ESX host prior to upgrading?
|
Put your host into Maintenance Mode.
|
|
|
What network adapters are supported in VMware ESX 3.x?
|
Broadcom
Intel |
|
|
Which tools can be used to upgrade ESX\ESXi 3.x to VMWare 4?
|
vCenter Update Manager
vSphere Host Update Utility |
|
|
What tools can be used to install patches on an ESX host via the command line?
Does it support rollback? |
esxupdate
no Patch history is still logged to the /var/log/vmware/esxupdate.log |
|
|
What is the maximum storage capacity for a VMFS 3 volume?
What is the maximum size for for a DATASTORE? |
2 TB
64Tb which is done by using the maximum of 32 (2TB LUNs) extents |
|
|
Which tools is used to determine the necessary hardware requirements to run your new infrastructure for your conversion from physical machines to an environment with ESX 4 host servers?
|
VMware Capacity Planner from your hardware vendor
|
|
|
How do you configure VMware ESX to boot from a fibre channel SAN LUN?
|
configure the server BIOS to designate the fibre channel HBA card as the boot controller and configure the fibre channel controller to initiate a connection to the target boot LUN
|
|
|
Which file should be modified to change the default name resolution behavior of your VMware ESX 4.0 host to perform host name resolution using DNS first and then the hosts file?
|
Modify /etc/nsswitch.conf
|
|
|
Name Two ways to enable NTP traffic through the Service Console firewall
|
Run esxcfg-firewall –e ntpClient from the command line
In the VIC, select your server, go to the Configuration Tab, select Security Profile, click Properties, and check the box next to NTP Client |
|
|
What are Host Profiles used for in VMware ESX 4?
|
Host profiles are used to apply and monitor configurations to ESX and ESXi 4 hosts
|
