• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/12

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

12 Cards in this Set

  • Front
  • Back

What type of grease would be used to lubricate a taper plug valve or gas tap?


i Graphite grease


ii Silicone grease


iii Bearing Grease


iv Non-Setting Grease

A. Graphite grease



What name is given to the valve used to turn off the supply gas to a cooker with a drop down lid?


i Ball valve


ii Safety cut off valve


iii Pedestal valve


iv Solenoid valve

A. Safety cut off valve



The term CREEP in relation to a regulator refers to?




i Let-by of the regulator valve when the regulator is locked up


ii Let-by of the regulator valve when the regulator is working


iii Variations in working pressure corresponding to varying throughputs


iv A temporary reduction in working pressure caused by a significant increase in gas



A. Let-by of the regulator valve when the regulator is locked up

A zero rated regulator?


i Supplies gas at 0m3-1 when the air supply fan is operating


ii Supplies gas at 0mbar when the air supply fan operates at max speed


iii Is rated for any gas type


iv Supplies gas at atmospheric pressure when the air supply operates at varying speeds





A. Supplies gas at atmospheric pressure when the air supply operates at varying speeds

A liquid expansion, thermostatic valve is most likely to be found on?


i Combi


ii System boiler


iii Gas cooker


iv Gas fire

A. Gas cooker

A liquid expansion, thermostaticswitch is most likely to be found on?




i Warm air unit


ii CH boiler


iii Gas cooker


iv Gas fire

A. CH boiler

Flame rectification current is normally?




i DC and between 10 & 35 micro amps


ii AC and between 5 &10 volts


iii DC and between 15 & 20 volts


iv AC and between 5 & 30 micro amps

A. AC and between 5 & 30 micro amps

A cooker hotplate burner is fitted with a thermo electric FSD what is the maximum time it should take to respond to flame failure?




i 30 seconds


ii 60 seconds


iii 90 seconds


iv 180 seconds

A. 90 Seconds

Which of the following controls is not normally incorporated into a multifunctional valve?




i Regulator


ii Thermo electric FSD


iii Solenoid


iv Igniter

A. Igniter

If the pressure sensing tubes were removed from a pressure switch and the appliance was then put into operation, then?


i The fan will not run?


ii There will be no attempt at ignition


iii The appliance will operate as normal


iv The appliance will overheat

A. There will be no attempt at ignition

What control is specifically required for an open flued gas fire installed in a bedroom




i ASD


ii Thermo electric FSD


iii Rectification (ionisation) FSD


iv Carbon monoxide detector

A. ASD

Interrupted thermocouple circuits are normally arranged to protect against?




i Spillage of products of combustion


ii overheating of the heat exchanger


iii either a or b


iv Vitiated atmosphere

A. either a or b