Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
49 Cards in this Set
- Front
- Back
When connectionless protocols are implemented at the lower layers of the OSI model, what is usually used to acknowledge that the data was received and to request the retransmission of missing data?
|
an upper-layer, connection-oriented protocol or service
|
|
Refer to the exhibit. Each media link is labeled. What type of cable should be used to connect the different devices?
|
Connection 1 – straight-through cable
Connection 2 – crossover cable Connection 3 – straight-through cable |
|
Which OSI layer does IP rely on to determine whether packets have been lost and to request retransmission?
|
transport
|
|
Refer to the exhibit. What is the correct destination socket number for a web page request from Host A to the web server?
|
198.133.219.25:80
|
|
A PC can not connect to any remote websites, ping its default gateway, or ping a printer that is functioning properly on the local network segment. Which action will verify that the TCP/IP stack is functioning correctly on this PC?
|
Use the ping 127.0.0.1 command at the command prompt.
|
|
Which type of media is immune to EMI and RFI? (Choose two.)
|
100 Base-FX
1000 Base LX |
|
Refer to the exhibit. The command that is shown was issued on a PC. What does the IP address 192.168.33.2 represent?
|
primary domain name server for the host
|
|
Refer to the exhibit. The diagram represents the process of sending email between clients. Select the list below that correctly identifies the component or protocol used at each numbered stage of the diagram.
|
1.MUA 2.SMTP 3.MTA 4.SMTP 5.MTA 6.MDA 7.POP 8.MUA
|
|
What is true regarding network layer addressing? (Choose three)
|
heirarchical
uniquely identifies each host contains a network portion |
|
Which OSI layers offers reliable, connection-oriented data communication services?
|
transport
|
|
Examine the graphic with current configurations. Host A in the Clerical offices failed and was replaced. Although a ping to 127.0.0.1 was successful, the replacement computer can not access the company network. What is the likely cause of the problem?
|
subnet mask incorrectly entered
|
|
Refer to the exhibit. Host A attempts to establish a TCP/IP session with host C. During this attempt, a frame was captured with the source MAC address 0050.7320.D632 and the destination MAC address 0030.8517.44C4. The packet inside the captured frame has an IP source address 192.168.7.5, and the destination IP address is 192.168.219.24. At which point in the network was this packet captured?
|
leaving Dallas
|
|
Refer to the exhibit. What two facts can be determined from the information that is given? (Choose two.)
|
The destination port indicates that an HTTP session has been initiated.
The data listed is associated with the transport layer. |
|
On the basis of the IP configuration that is shown, what is the reason that Host A and Host B are unable to communicate outside the local network?
|
The gateway address was assigned a broadcast address.
|
|
Which of the following are the address ranges of the private IP addresses? (Choose three.)
|
10.0.0.0 to 10.255.255.255
172.16.0.0 to 172.31.255.255 192.168.0.0 to 192.168.255.255 |
|
Which combination of network id and subnet mask correctly identifies all IP addresses from 172.16.128.0 through 172.16.159.255?
|
172.16.128.0 255.255.224.0
|
|
Which password is automatically encrypted when it is created?
|
enable secret
|
|
Which three statements characterize the transport layer protocols? (Choose three.)
|
TCP and UDP port numbers are used by application layer protocols.
TCP uses windowing and sequencing to provide reliable transfer of data. TCP is a connection-oriented protocol. UDP is a connectionless protocol. |
|
When must a router serial interface be configured with the clock rate command?
|
when the interface is functioning as a DCE device
|
|
Which two functions of the OSI model occur at layer two? (Choose two.)
|
physical addressing
media access control |
|
A routing issue has occurred in you internetwork. Which of the following type of devices should be examined to isolate this error?
|
router
|
|
Refer to the exhibit. With the router running NAT, what IP addresses can be applied to the computer to allow access to the Internet? (Choose three)
|
192.168.18.49
192.168.18.52 192.168.18.59 |
|
Due to a security violation, the router passwords must be changed. What information can be learned from the following configuration entries? (Choose two)
Router(config)# line vty 0 3 Router(config-line)# password c13c0 Router(config-line)# login |
The entries specify four Telnet lines for remote access.
Access will be permitted for Telnet using “c13c0″ as the password. |
|
As network administrator, what is the subnet mask that allows 510 hosts given the IP address 172.30.0.0?
|
255.255.254.0
|
|
A network administrator remotely accesses the CLI of RouterB from PC1 using Telnet. Which statement is true about this connection?
|
he connection is made through a VTY session on the router.
|
|
Refer to the exhibit. Cable 1 and cable 2 have the ends wired for specific physical layer requirements. The table lists each segment by number and the cable which has been installed by the network technician between the network components on that segment. From the data given, which segments have the correct cable installed? (Choose three.)
|
segment1
segment3 segment4 |
|
What three statements are true about the IP configuration that is shown? (Choose three.)
|
The address that is assigned to the computer represents private addressing.
The computer is unable to communicate outside of the local network. The prefix of the computer address is /27. |
|
Which three IPv4 addresses represent a broadcast for a subnet? (Choose three.)
|
172.16.4.63 /26
172.16.4.191 /26 172.16.4.95 /27 172.16.4.95 /27 |
|
Refer to the exhibit. A network technician is trying to determine the correct IP address configuration for Host A. What is a valid configuration for Host A?
|
IP address: 192.168.100.20; Subnet Mask: 255.255.255.240; Default Gateway: 192.168.100.17
|
|
The Layer 4 header contains which type of information to aid in the delivery of data?
|
service port number
|
|
During the encapsulation process, which identifiers are added at the transport layer?
|
two applications communicating the data
|
|
Refer to the exhibit. Assume all devices are using default configurations. How many subnets are required to address the topology that is shown?
|
3
|
|
Refer to the exhibit. Which logical topology best describes the exhibited network?
|
multiaccess
|
|
Refer to the exhibit. Host A is transmitting data to host B. What addresses will host A use to for the destination IP
and MAC addresses in this communication? |
Destination MAC: EEEE:EEEE:EEEE Destination IP: 172.22.0.75
|
|
Refer to the exhibit. A router, whose table is shown, receives a packet that is destined for 192.168.1.4. How will router treat the packet?
|
The packet will be forwarded to the destination host.
|
|
Refer to the exhibit. Which set of devices contains only intermediary devices?
|
A, B, D, G
|
|
Refer to the exhibit. A technician is working on a network problem that requires verification of the router LAN interface. What address should be pinged from this host to confirm that the router interface is operational?
|
The Default Gateway
192.168.254.1 |
|
Which prompt represents the appropriate mode used for the copy running-config startup-config command ?
|
Switch-6J#
|
|
Which range of port numbers are reserved for services that are commonly used by applications that run on servers?
|
0 to 1023
|
|
Refer to the exhibit. Which two statements describe the information that is represented in the header? (Choose two)
|
The destination port indicates a Telnet session.
The return segment will contain a source port of 23. |
|
Refer to the exhibit. Which two statements describe the information that is represented in the header? (Choose two)
|
The destination port indicates a Telnet session.
The return segment will contain a source port of 23. |
|
In a Cisco IOS device, where is the startup-configuration file stored?
|
NVRAM
|
|
Refer to the exhibit. What two facts can be determined about the exhibited topology? (Choose two)
|
A single broadcast domain is present
Five collision domains exist. |
|
What are three characteristics of CSMA/CD? (Choose three)
|
A device listens and waits until the media is not busy before transmitting.
All of the devices on a segment see data that passes on the network medium. After detecting a collision, hosts can attempt to resume transmission after a random time delay has expired. |
|
Refer to the exhibit. What is required on host A for a network technician to create the initial configuration on Router1?
|
a terminal emulation program
|
|
Refer to the exhibit. The tracert command is initiated from PC1 to PC4. Which device will send a response to the initial tracert packet from PC1?
|
London
|
|
Refer to the exhibit. When computer A sends a frame to computer D, what computers receive the frame?
|
only computer D
|
|
Refer to the exhibit. What function does router RT_A need to provide to allow Internet access for hosts in this network?
|
address translation
|
|
Refer to the exhibit. The network containing router B is experiencing problems. A network associate has isolated the issue in this network to router B. What action can be preformed to correct the network issue?
|
issue the no shutdown command on interface FastEthernet 0/1
|