Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
27 Cards in this Set
- Front
- Back
When is fuel and ignition introduced in a normal engine start? |
4 seconds after 15% NG |
|
When does the engine start control valve close? |
When commanded closed by MC VIA FADEC at approx 65% NG |
|
What are the three FADEC closed loop circuits and their respective valves? |
LVIT - FPMU main Metering Valve, LVDT - CVG Control Valve, and RVDT - PCU Servo Valve. |
|
What is the purpose of the FPMU Vent Valve Solenoid? |
The air vent solenoid valve is energised between 2 and 59% NG to remove air from the fuel on engine start up through the air vent valve. At 59% NG the solenoid is de-energised. |
|
What is the fuel boost pump pressure? |
15-24 PSI |
|
What are the prop shift critical RPM ranges? |
52-68 and 75-85 NP |
|
The green 'B' is active between which beta angles? What does it stand for? |
Active between 23 and 10.5 degrees beta angle, below 145 KIAS, ground range ready. |
|
What beta angle is the Hydromechanical low pitch stop? |
13 +/- 0.2 degrees beta |
|
What is the beta angle for MAX REVERSE NGI? |
-17 +/- 0.2 degrees |
|
What is the beta angle for MAX REVERSE LSGI? |
-14 +/- 0.2 degrees |
|
What are the NP overspeed circuits? |
103-105 Overspeed Governor 106 FADEC Fuel Trimming 119 Independent Overspeed Shut-down |
|
What are the NG Overspeed Circuits? |
103 FADEC Fuel Trimming 109 Independent Overspeed Shut-down |
|
When should EPSI indication occur? |
Within 15 seconds of NG rotation. |
|
When should GPSI indication occur? |
Within 15 seconds of NP rotation. |
|
When should HYD indication occur? |
Within 25 seconds of NP rotation. |
|
What monitors and controls the engine anti-ice valve? |
FADEC monitored, NIU controlled. |
|
What monitors and controls the Oil Cooler Augmentation Valve? |
NIU monitored and controlled. |
|
What are the conditions for oil cooler augmentation to occur? |
WOW Airspeed <50KIAS Oil temp > 82 degrees Oil cooler flap > 80% PLA < FI Oil cooler flap - Auto |
|
What manifold pressure should be observed with FLT STA air con on, NSOV open and PLA at GI? |
Min 37 PSI |
|
What two conditions must be met to transition from 'alpha' to 'beta'? |
Airspeed <145 kt Beta < 23 degrees |
|
What is the Auxiliary Hydraulic pressure limit? |
2900-3300 PSI |
|
What are the utility and booster hydraulic pressure limits? |
2900-3200 PSI |
|
When is the APU deemed on-screen? |
>95% rpm |
|
The APU is not to be started if battery volts are less than what? |
22v |
|
What are the operating restrictions for 37SQN? |
4 Engines NGI |
|
What are the Curfew times for RAAF Richmond? |
Monday -Thursday 2300-0700 Friday -Sunday 2200-0700 |
|
Recite the big table thing :) |
|