Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
12 Cards in this Set
- Front
- Back
The Air Data Switch applies heat to what components?
|
Pitots
Rudder Limiter (primary) AOA vanes static ports RAT probes (ram air temp) |
|
What component is NOT heated on the ground?
|
RAT probes
|
|
Define Icing conditions?
|
TAT less than 6C and high humidity, or visible moisture. Or frost or ice is present on lower surface of either wing
|
|
What are the recommended procedures to use the aircraft Engine and Wing Anti-ice systems?
|
Engine anti-ice should be ON whenever icing conditions exist or are expected. Airfoil anti-ice should also be used if conditions warrant.
|
|
Bleed air for Wing Anti-ice comes from what source?
|
Engine bleed air (LEFT side)
|
|
What is heated with wing anti-ice ON?
|
Engine bleed air flows through ducts in the wing leading edge to anti-ice the slats
|
|
Bleed air for the Tail comes from what source?
|
Engine Bleed air (RIGHT side)
|
|
What is heated with Tail Anti-ice ON?
|
Horizontal stabilizer leading edge and tail leading edge
|
|
What is heated when Engine Anti-ice switch is on?
|
Engine nose cowling
|
|
Is the Engine N1 fan's nose dome heated?
|
No
|
|
Windshield Anti-ice applied to what windows?
|
The 3 pilot windshields are electrically anti-iced and anti-fogged. The clearview and overhead windows are only anti-fogged.
|
|
Besides anti-icing, what else does windshield heat do?
|
Strengthens window for bird strikes
|