Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
35 Cards in this Set
- Front
- Back
Active ingredient
|
Toxic chemical that controls target pest
|
|
Abrasive
|
Capable of wearing away or grinding down another object
|
|
Aerosol
|
Fine spray produced under pressurized gas that leaves fine droplets of pesticide suspended in air
|
|
Agitation
|
Process of stirring or mixing
|
|
Alkaline
|
Opposite of acidic; having pH greater than 7
|
|
Carrier
|
Primary material used to allow pesticide to be dispersed effectively
|
|
Compatibility
|
Ability of two compounds to be mixed without affecting each other's chemical properties
|
|
Dilute
|
To make less concentrated
|
|
Emulsion
|
Mixture of two or more liquids that are not soluble in one another; one is suspended as small droplets in the other
|
|
Insoluble
|
Does not dissolve in liquid
|
|
Nontarget
|
Any site or organism other than the site or pest toward which the control measures are being directed
|
|
Petroleum-based
|
Made from petroleum products such as xylene, refined oil, kerosene
|
|
Soluble
|
Able to be dissolved in another substance
|
|
Solution
|
Mixture of substances without chemical change taking place
|
|
Solvent
|
Liquid, such as water, kerosene, xylene, or alcohol, that will dissolve pesticide (or other substance) to form solution
|
|
Suspension
|
Substance that contains undissolved particles mixed throughout liquid
|
|
Target pest
|
Pest toward which control measures are being directed
|
|
ULV (ultra-low volume)
|
Concentrations that approach 100% active ingredient
|
|
Volatile
|
Evaporating rapidly; turning easily into a gas or vapor
|
|
What is a pesticide formulation?
|
A mixture of active and inert (inactive) ingredients that forms a pesticide product
|
|
What is the difference between active and inert ingredients?
|
ACTIVE ingredients are the chemicals that control pests and have toxicity.
INERT ingredients are added to make the product safer, more effective, easier to measure, mix, and apply, and more convenient to handle |
|
What are the factors that you should consider when you have a choice of formuations for a pest-control task?
|
1. Right equipment
2. Apply safely 3. Reach the target 4. Stay in place long enough 5. Harm to target site |
|
If you had a choice of either a wettable powder or granular pesticide, which would be best if drift were a major concern?
|
Granular pesticide
|
|
If you had a choice of either a wettable powder or granular pesticide, which would be best if you needed the pesticide to stay on a surface that is not level, such as foliage?
|
Wettable powder
|
|
If you had a choice of either a wettable powder or an emusifiable concentrate, which would be better if you were concerned about harming the treated surface?
|
The wettable powder, because ECs are corrosive and may cause pitting, discoloration, or other damage.
|
|
If you had a choice of either a wettable powder or an emusifiable concentrate, which would be better if you were diluting with very hard or alkaline water?
|
The EC. Wettable powders are difficult to mix in very hard or alkaline water.
|
|
Why are adjuvants sometimes added to pesticide formulas?
|
To increase effectiveness or safety
|
|
What type of adjuvant would be used to reduce drift?
|
Foaming agent, thickener
|
|
What type of adjuvant would be used to coat a surface evenly?
|
Spreader
|
|
What type of adjuvant would be used for combining two or more pesticides in one application?
|
Compatibility agent
|
|
Herbicide
|
Type of pesticide used against weeds
|
|
Microbial insecticide
|
Microorganisms or microbes that biologically control insect pests
|
|
Avicide
|
Designed to control pest birds
|
|
Rodenticide
|
Designed to kill rodents
|
|
Microencapsulated pesticides
|
Particles of pesticides in plastic coating. Slow release.
|