Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
27 Cards in this Set
- Front
- Back
Where is the proof testing/recertification of lifting slings accomplished |
Rework facility |
|
What is the maximum number of broken wires allowed on a wire rope lifting sling |
3 per inch |
|
P-25 has how many relief valves for the A triple F proportioning systen |
2 |
|
When should a load test for the crash cranes be scheduled |
Annually, after repair or replacement of a major component and prior to deployment |
|
In what publication can you find the minimum occupational requirements for advancement |
NAVPERS 18068 |
|
On what date did BUPERSNOTE 1440 announce |
24 February 1966 |
|
What is the first thing you should do when a piece of equipment comes in for inspection |
Clean it |
|
Which of the following troubleshooting aids are the most useful to you when troubleshooting an electrical malfunction |
Wiring diagrams, experience, MIM, and functional drawings |
|
What are the primary causes of premature engine failures in support equipment |
Dirt and water in fuels |
|
Gasoline evaporates at which of the following temperatures |
Any temperature |
|
Which of the following properties will a manufacturer consider in specifying a fuel for a diesel engine |
Antiknock, viscosity, and volatility |
|
Which of the following statements defines corrosion |
Deterioration of metal by chemical or electrochemical process |
|
In the electrochemical attack of corrosion, which of the following climates is more serious factor |
Wet and humid |
|
NC-10C, has how much K V A generator |
90 K V A |
|
To determine the correct jack for a specific aircraft, you should refer to which of the following publications |
19-70-46 |
|
What is the weight bearing capacity for a B-5A stand |
600 pounds |
|
What is the preferred method of installing a new member in a frame that has been badly distorted |
Use hot rivets to join the two pieces |
|
What are the two types of axles used on S.E. |
Driving and nondriving |
|
How are drive axles secured to an item of S.E. |
They are encased in a housing |
|
What are the two types of springs used on S.E. |
Coil and leaf springs |
|
Which of the following components keep the front wheels in proper alignment |
The tie rod |
|
The pitman arm connects the steering gearbox to which of the following components |
The connecting rod |
|
What are the principal parts of a steering gear unit |
The worm gear and sector |
|
Which of the following conditions can cause excessive play in the steering system |
Improper adjustment of the steering linkage |
|
Front-end geometry include which of the following terms |
Caster, camber, and pivot inclination |
|
Which of the following statements best describes wheel caster |
The number degrees the steering knuckle is tilted to the rear or front |
|
On a drum type brake system, which of the following malfunctions, if any, will occur if the anchor pin is too near the center of the drum |
The shoe will automatically lock when brakes are initially applied |