Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
10 Cards in this Set
- Front
- Back
When upgrading only a computer's CPU, which of the following would be the most likely replacement for a Celeron 466MHz CPU?
A. Pentium 4 Xeon 2.0 B. Pentium 3 1 GHz C. Pentium 2 MMS-450 D. AMD K7-750 |
B. Pentium 3 1 GHz
|
|
What is the default I/O address and interrupt for COM2?
A. 2F8 / IRQ 4 B. 3E8 / IRQ 3 C. 2F8 / IRQ 3 D. 2E8 / IRQ 4 |
C. 2F8 / IRQ 3
|
|
There is one floppy drive in a computer and it is not working. The drive activity light is on continuously. Which of the following is most likely the cause?
A. The floppy cable is defective B. The floppy I/O controller is defective C. The floppy cable is reversed on one end D. The floppy drive is defective |
C. The floppy cable is reversed on one end
|
|
What information should be gathered from a user when troubleshooting a complaint that an applicant no longer works on their PC? (Select THREE)
A. Recent changes made to the PC B. The users level of technical skill C. The pattern or frequency of the problem D. The first occurance of the problem E. The age of the PC |
A. Recent changes made to the PC
C. The pattern or frequency of the problem D. . The first occurance of the problem |
|
Which of the following are used to avoid ESD (Electrostatic Discharge)? (Select THREE)
A. Grounded workbenches B. Ground fault interrupters C. Static wrist straps D. Static Mats E. Uninterruptable Power Supply (UPS) |
A. Grounded workbenches
C. Static wrist straps D. Static Mats |
|
Which of the following RAM types MUST be installed in matched pairs?
A. DDR B. DRAM C. RAMBus D. SDRAM |
C. RAMBus
|
|
What is the Front Side Bus speed for an AMD XP 2100+ CPU?
A. 100 MHz B. 150 MHz C. 166 MHz D. 256 MHz |
D. 256 MHz
|
|
Which component of a laser printer positively charges the drum?
A. Transfer corona wire B. Charge corona wire C. Fuser D. Toner assembly |
B. Charge corona wire
|
|
Which of the following methods can be used to set ip an IP address on a workstation? (Select TWO)
A. A static address is configured on the workstation B. A dynamic address is configured on the workstation C. A dynamic address is obtained from a DHCP server D. A static address is obtained from a DHCP server |
A. A static address is configured on the workstation
C. A dynamic address is obtained from a DHCP server |
|
What is the minimum UTP cable specification for 100 Mbps up to 100 meters?
A. CAT1 B. CAT3 C. CAT5 D. CAT5e E. CAT6 |
C. CAT5
|