Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
71 Cards in this Set
- Front
- Back
How many windows on the cp140 |
2 overwing escape hatch, 4 observer, 7 cockpit, 2 dinette, 1 galley |
|
How many of the windows are heated |
3- pilot, Co pilot, FE |
|
How are the observer windows installed |
From the inside using 94 lock bolts and collars |
|
What is the purpose of the vent hole and nylon braided cord at the bottom of the over wing escape hatches |
To remove moisture and condensation from between the panes |
|
What are the 3 front windows in the cockpit made of |
Outer tempered glass ply Polyvinyl butyral ply Inner tempered glass ply Polyvinyl butyral ply Fragmentation shield (tempered glass ply) |
|
What do the two curved side window panels consist of? |
Two panes of transparent acrylic plastic sheets biaxially stretched, separated by a lamination of poly vinyl butyral (or cast in place interlayers) |
|
When is the override switch utilized? |
In extreme cold conditions |
|
How many sub systems does the fwd window heating system consist of |
2, the pilot sub system and the co pilot FE sub system |
|
What temp does the windshield temperature control unit maintain the windshield temp at |
32-38°C |
|
What does it indicate when the cycling lights are cycling rapidly |
Icing is severe, windshield heat control switch must be set to high |
|
Where are the windshield heat power relays located |
In the FELC |
|
What are the settings for the windshield heat control switches |
Low, off, high |
|
How many volts does the windshield heat power relay require |
28 VDC |
|
How many output connections do the power transformers have |
3 (A,B,C) |
|
What are the power transformers A, B and C used for |
To electrically match the power of the transformers output to the windshield due to coating thickness during manufacture |
|
Before selecting HIGH the control switch must be selected to LOW for at least 10 minutes. Why? |
To prevent windshield thermal shock |
|
The side windshield temp control units maintain what temperature |
49°C plus/minus 5.5° |
|
How many thermistors does the forward windshield each have |
1 each |
|
How many wire grid sensors are on the curved side windshields |
2 per windshield |
|
Where are the heating elements located for the forward windshields |
In the poly vinyl butyral layer |
|
Where are the heat control switches located |
On the prop and ice control panel |
|
Where is the prop and ice control panel located |
LH inboard overhead panel |
|
How are the doors and hatches installed in CP140 |
From the inside |
|
How are the push plates linked to the latches on the escape hatches |
Mechanically |
|
How is the main cabin door hinged |
Centrally mounted hinge on the FWD side of the door |
|
How long is the cabin door escape rope |
15 ft |
|
Which 3 doors are connected to the DOOR OPEN light on the vertical annunciator panel |
Photo illuminator door, main cabin door, hydraulic service center door |
|
What should you remember to do when opening the hydraulic service center door |
Stow handle to prevent damage |
|
How many light switches are on the upper part of the main cabin door |
2 |
|
If the door open light is on, but all doors are closed, what is the most likely cause? |
One of the doors is misadjusted |
|
What is the only externally opening door on the CP140 |
smoke removal scoop |
|
How is the auxiliary escape hatch opened |
Hinged on the aft side and swings inward |
|
How many latch assy's keep the nose radome closed |
6 |
|
What retains the tail cone in the closed position |
4 spring leaf fasteners |
|
All hatches and doors on CP140 have what in common |
They are all plug type |
|
The main cabin door has how many door open switches |
3 (two upper, one lower) |
|
Which doors have door open switches |
Main cabin door, hydraulic service center, photoilluminator door |
|
All doors and hatches are equipped with what |
Emergency opening mechanisms, adjustable plates and stops, pressurization seals and bonding clips |
|
What should be carried out after any door has been rigged or adjusted |
Pressuriaztion test TBCO |
|
What is the purpose of the cabin windows? |
Allows crew to look outside of aircraft |
|
Which windows arw not installed.from the inside |
Cockpit windows |
|
Which windows have an insert lamination between panes? |
Observer and dinette |
|
The overwing escape hatch windows are comprised of? |
Plexiglass panes |
|
Which cockpit windows are not heated/defogging? |
Skylight windows |
|
What is the purpose of the fwd windshield heating? |
-To prevent weather conditions from affecting pilot -keeps windows flexible for strikes |
|
What are the three fwd windshield resistance ratings |
RA, RB, RC |
|
Which type of sensor is the thermistor |
Variable resistance type sensor |
|
How many cycling lights are there |
2 (one per control unit) |
|
What colour are the cycling lights |
Yellow or cautionary in colour |
|
When do cycling lights illuminate |
When heat is applied |
|
If windshield is cold, selection must be set to low for ________ before selecting high |
10 minutes |
|
How many wire grid sensors are in the 2 curved side cockpit windows |
4 (2 per window) |
|
How many of the wire grid sensors are used at any given time |
1 |
|
Where is the load monitor control relay located |
In the MELC |
|
What are the 3 door open light switch positions |
Aft center, fwd upper, aft lower |
|
The smoke scoop directs ________ through the plane? |
Ram air |
|
What are the tail cone spring leaf fasteners constructed from |
Non magnetic material |
|
Are skylight windows integral to viewing? |
No |
|
The mad boom assy is secured shut with what? |
6 latch assy's |
|
Where do the side windows draw their power from |
Essential main DC bus |
|
Where does the fwd windshield draw its power from? |
Monitorable essential DC bus |
|
Where are the windshield control switches located |
Overhead instrument panel (prop and ice control LH) |
|
What does the ladder interlock switch prevent |
Door from.opening when ladder is extended |
|
How many windows does CP140 have? |
16 |
|
The center cockpit window is comprised of what 3 types of panes? |
Outer tempered glass poly vinyl butyral Inner tempered glass |
|
How many support arms secure the nose radome |
2 |
|
All tools used on mad boom must be |
Non magnetic |
|
How is the TCDL radome secured |
20 screws and PRC |
|
How many door open light switches on hydraulic service center |
1 |
|
How is the hydraulic service center secured |
Via locking pin on the inside |
|
How many thermistors total |
3 (1 per windshield) |