Study your flashcards anywhere!
Download the official Cram app for free >
- Shuffle
Toggle OnToggle Off
- Alphabetize
Toggle OnToggle Off
- Front First
Toggle OnToggle Off
- Both Sides
Toggle OnToggle Off
- Read
Toggle OnToggle Off
How to study your flashcards.
Right/Left arrow keys: Navigate between flashcards.right arrow keyleft arrow key
Up/Down arrow keys: Flip the card between the front and back.down keyup key
H key: Show hint (3rd side).h key
A key: Read text to speech.a key
9 Cards in this Set
- Front
- Back
Each connected serial interface must have an IP address and subnet mask configured with the following commands,
|
Router(config) interface serial 0/0
Router(config-line)# ip address <ip address> <netmask> |
|
Serial interfaces require a clock signal to control the timing of the communications. In most environments a
|
DCE deivce such as a CSU/DSU will provide the clock.
|
|
Cisco routers are DTE devices but they can be configured as
|
DCE devices
|
|
Each connected serial interface must have an IP Configure the IP address with the following commandsaddress and subnet mask
|
Router(config) interface serial 0/0
Router(config-line)# ip address <ip address> <netmask> |
|
Serial interfaces require a clock signal to control the timing of the communications. In most environments a
|
DCE deivce such as a CSU/DSU will provide the clock.
|
|
Cisco routers are DTE devices but they can be configured as
|
DCE devices
|
|
On serial links that are directly connected, such as in a lab environment, one side must be considered a
|
DCE and provide clocking signal
|
|
On serial links that are directly connected, such as in a lab environment, one side must be considered a
|
DCE and provide clocking signal
|
|
The clock is enabled and speed is specified with the command
|
clock rate
|