Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
20 Cards in this Set
- Front
- Back
Types of prints |
Plan, elevation, and section |
|
Diameter symbol |
Back (Definition) |
|
B. C. |
Bolt circle |
|
N.S. & F.S. |
Near side and far side |
|
T.O.C. |
Top of concrete |
|
Front (Term) |
Section line |
|
Prints drawn by outside vendors are known as ? |
Foreign Prints |
|
How are rebar sizes expressed |
In 1/8” increments |
|
Do wiring diagrams show front or rear view? |
Rear view? |
|
How do you mark removals on a print? |
Series of X’s over the wire and then shaded red |
|
What are the two most common shapes for anchor bolts? |
L & J |
|
When are bell footings used? |
When soil conditions do not provide sufficient support |
|
Concrete formula |
Length x width x depth (in feet) ——————————————— 27 |
|
What other types of concrete joints? |
Construction joints, control joints, isolation joints, and expansion joints |
|
How long for concrete to reach full strength? |
28 days |
|
How are wire additions to a print marked? |
Wires drawn in black pen and then shaded blue |
|
What is a slump test used for? |
To measure consistency of concrete |
|
What is concrete composed of? |
Fine aggregate, coarse aggregate, cement, and water |
|
What is used to change direction of a pull, tigger, etc.? |
Snatch block |
|
What is your benchmark? |
A permanent Reference point used for elevation |