Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
21 Cards in this Set
- Front
- Back
|
Is there any requirement for cleaning an aircraft prior to an annual or 100 hour inspection? |
It is not only good, common sense, but it is a legal requirement as specified in FAR Part 43, ADiscuss the general precautions that should be observed one washing an airplane.ppendix D. |
|
|
Discuss the general precautions that should be observed when washing an airplane. |
Avoid or protect areas, which may be damaged or contaminated, such as: Pitot andWhat are some of the more common light duty cleaning agents? static ports, hinges, sealed areas, and bearings. |
|
|
What are some of the more common light-duty cleaning agents? |
Soap or detergents and water |
|
|
What materials are commonly used as heavy duty cleaners? |
Solvents and emulsions |
|
|
What are the preferred cleaners for plastic surfaces such as windshield? |
Mild soap and water or a manufacturer approved cleaner. |
|
|
What type of cleaning agents should be used to remove grease, oil or fuel from aircraft tires? |
Soap and water |
|
|
Give at least three examples of the factors that cause or influence corrosion. |
1) The environmental conditions 2) The presence of dissimilar metals 3) The type of metal 4) The presence of electrolytes and/or contaminants 5) The condition of protective coatings |
|
|
Name at least three forms of corrosion. |
1) Surface 2) Intergranular 3) Filliform 4) Dissimilar metal (or galvanic) 5) Oxidation 6) Pitting 7) Stress 8) Fretting |
|
|
Name at least one cause of filliform corrosion. |
1) Improper or incomplete curing of a wash primer prior to painting 2) Failure to completely wash off acidic surface contamination |
|
|
What are the visible signs of filliform corrosion? |
Blistered paint services or worn or thread-like tracks or patterns under the paint. |
|
|
What are the two primary factors that may cause development of stress corrosion cracks? |
A corrosive environment and sustained tensile stress |
|
|
What are the visible signs of fretting corrosion? |
The corrosion residue has a dark, smoky appearance and often appears around and is streaming back from rivet heads. |
|
|
What are piano-type hinges prime spots for corrosion? |
Steel pin and aluminum hinge material are dissimilar metals and the hinge design tends to trap moisture and contaminants. |
|
|
What is the best way to protect piano hinges from corrosion? |
Keep them clean and properly lubricated. |
|
|
Provide at least four examples of procedures used to prevent corrosion. |
1) cleaning 2) lubrication 3) treatment 4) sealing 5) inspection 6) installing protective covers 7) keeping drain holes free and clear |
|
|
Describe the tools that should be used to remove the corrosion from anodized aluminum surfaces. |
Nylon scrubber pads such as scotch bright, bristle brushes, aluminum wool or aluminum wire brushes. |
|
|
Describe the effects of using steel brushes or steel wool to remove corrosion from aluminum services. |
Steel brushes or steel wool must not be used to clean aluminum because steel particles can become embedded in the aluminum and cause corrosion. |
|
|
What is the purpose of Alodine? |
Alodine is a chemical process that deposits a protective film on aluminum alloy. This film improves corrosion resistance and paint adhesion. |
|
|
For what reason should you avoid cleaning anodized aluminum surfaces with aluminum metal polish? |
Aluminum metal polish should not be used on anodized aluminum surfaces because it will remove the oxide coating. |
|
|
Why should aircraft fabrics and plastics be cleaned only with recommended cleaners? |
Recommended cleaners cause the least amount of deterioration or damage. |
|
|
List at least five examples of areas in an aircraft that are prone to corrosion. |
1) battery compartments 2) exhaust trail areas 3) bilge areas 4) vent areas 5) landing gear and wheel wells 6) fuel tanks 7) wings flap recesses 8) around and below galleys and lavatories 9) piano hinges 10) any area that can trap water |
