• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/17

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

17 Cards in this Set

  • Front
  • Back
3 factors that determine stopping distance
perception distance - 3/4 sec 60 feet at 55mph
reaction distance 3/4 sec 60 feet at 55mph
braking distance
cone placement on two land road with traffic in both directions or undivided highway
place warning devices within ten feet of the front or rear corners to mark the location of the vehicle and 100 feet behind and ahead of the vehicle, on the shoulder or in the lane in which you stopped.
Cone placement on a hill
Back beyond any hill, curve, or other obstruction that prevents other drivers from seeing the vehicle within 500 feet.
cone placement on one way or divided highway
place warning devices 10 feet, 100 feet, and 200 feet toward the approaching traffic
examples of slippery roads
shaded areas, bridges, black ice, melting ice
When does low pressure warning device activate for braking system?
between 55 to 75 psi or one half the compressor governor cut-out pressure on older vehicles. The warning is usually a red light. A buzzer may also come on
static leak test
– 2 psi for single vehicles.
– 3 psi for a combination of two vehicles.
– 5 psi for a combination of three or more vehicles.
applied leakage test
After the system settles again, time for one minute. The air pressure should not drop more than:
– 3 psi for single vehicles.
– 4 psi for a combination of two vehicles.
– 6 psi for a combination of three or more vehicles.
Air Compressor Governor Cut-Out Pressure Test
The air compressor governor must cut-out prior to the needle reaching 130 psi. Where the needle stops rising is the governor cut-out pressure.
Air Compressor Governor Cut-In Pressure Test
Watch the air pressure gauge between pumps to identify when the compressor cuts in (needle starts to rise). This should occur no lower than 85 psi.
Check that the spring brakes come on automatically
Chock the wheels. Release all parking brakes and shut the engine off. Pump the brake pedal to reduce the air tank pressure. The trailer air supply valve knob should pop out when the air pressure falls to the manufacturer’s specifications (usually in a range between 20 to 45 psi)
Rate of air buildup
the pressure should build from 85 to 100 psi within 45 seconds in dual air systems.
test service brake
apply the brakes firmly using the brake pedal. Any pulling to one side, unusual feel, or delayed stopping action should be checked.
test parking brake
apply during a slow roll
DMV violation point counts?
Major violations and disqualification actions,
55 years
• Out-of-service violations and disqualification
actions, 15 years
• Collisions, serious violations and disqualification
actions, 10 years
• Railroad grade crossings and disqualification
actions, 4 years
• Minor convictions, 3 years
DMV you are considered a negligent operator if you have the following points per period:
4 points in 12 months
6 points in 24 months
8 points in 36 months
You must notify your employer within ___
days of all traffic violations (except parking).
30 days. This is true no matter what type of vehicle
you were driving.