Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
30 Cards in this Set
- Front
- Back
Use to prepare a granular material for particle size analysis by removing fines that may impede the separation process. |
Wet sieving |
|
Involves flow of water through a relatively short soil sample connected to a stand pipe which provides the water head and allows measuring the volume of water passing through the sample. |
Falling head permeability test |
|
An apparatus used in constant head permeability test-- a specimen cylinders with diameter of 8 or 12 times Maximum particle size |
Permeameters |
|
Basically consists of placing an inflatable cylindrical probe in a predrilled hole and expanding this probe while measuring the changes in volume and pressure in the probe. |
Pressure meter test |
|
Give at least 1 apparatus used in pipette sampling |
Sampling Pipette, Mechanical shaker, 9 glass weighing bottles, test sieve, balance, sample devider, drying oven etc. |
|
This test is used to determine the undrained shear strength of soils especially soft clays. This can be done in laboratory or in a field directly on the ground? |
Vane Shear Test |
|
It is a rounded silica sands of nearly pure quartz used in sand replacement method. |
Ottawa sand |
|
In Nuclear Density Test, what is the radioactive material that emits gamma radiation and can be translated to density by the use of detector? |
Cesium |
|
What is the highest acceptable wear due percentage? |
50 % |
|
What is the common abrasion method used? |
Los Angeles Abrasion Test |
|
It can be used to distinguish between silt and clay soils. These distinctions are used in assessing soils on which structures are to be built. |
Atterberg limits |
|
Standard groove cut in the soil pat in liquid limit test |
12.7mm |
|
It is used to determine the optimal moisture content and dry density. |
Proctor Test/Compaction Test |
|
What is the compactive effort for standard Proctor Test? |
ft^3 |
|
This test method can be used to determine porewater pressures developed during the penetration, thus termed piezocone |
Static Cone Penetration Test |
|
This method covers the determination of the consolidated drained shear strength of a soil material |
Direct Shear Test |
|
Fall of hammer in SPT is kept as ______? |
75 CM or 30 in |
|
Maximum blows that applied in SPT? |
100 blows |
|
Annular metal weight with a center hole approximately 54.0 me in diameter. 4. 54.0 mm in diameter |
Surcharge Weights |
|
This method provides for the determination of a material at Optimum Water Content or a range of water content from a specified compaction test and specified dry unit mass. |
California Bearing Ratio Test |
|
Used for determination of specific gravity of soil particles of both fine grained and coarse grained soils? |
Pycnometer |
|
Defined as the moisture content after which any further reduction of moisture does not cause volume reduction? |
Shrinkage limit of a soil |
|
Useful for titrations and also for boiling solutions when it necessary to keep evaporation to a minimum- |
Conical [ Erlenmeyer] Flask |
|
Provides shear strength parameter for total stress (i.e., short term) stability analysis, similar to the UU test? |
Consolidated, Undrained |
|
Specific gravity lies in the range of _____ to 2.80? |
2.65 |
|
Most accurate method used for the determination of water content in laboratory. |
Oven drying method |
|
It is a quick field method that is generally used when facility of oven is not available. |
Sand bath method |
|
In this method infrared radiation are use for drying of the moist sample. |
Torsional method |
|
What parameters should be an aggregate to consider as potentially ASR Reactive? |
0.04% @ 2 years. |
|
What are the 2 methods for dry density test provided in ASTM d7263? |
Method a: water displacement Method b: direct measurement |