Startle reaction

surface blocking the active surface sites in the LDH. The maximum photodegradation efficiency was obtained at the dye concentration of 1 x 10-5 M. 3.11.4. Recyclability of 2:1 Co/Ti LDH After each degradation cycle, the LDH was separated from the reaction system, was regenerated by washing it three times with de-ionized water followed by drying,…

This report gives an information which is related to the reaction between acidified potassium iodide and hydrogen peroxide. Before calculating the rate of this reaction, the reaction will be carried out 3 times and values will be got. A special timer will be used to measure the time. It could be expected and argued that each time will be able differ from the others in each reaction and it can be explained by changing the quantity of hydrogen peroxide. At the final, it will be obviously observed…

From the experimental study it is found that the heat transfer rate in notched fins is more than the un-notched fins. The average heat transfer coefficient increases with the heater input. It is clear that for the given heater input, average heat transfer coefficient of notched array is 30 to 40% higher than corresponding un-notched array. The average heat transfer coefficient for notched fin is better than un-notched fins. Also the copper gives more heat transfer rate than aluminum plate…

15SPE072X 27012016 EXPERIMENT 7: Cannizzaro reaction and reaction of benzaldehyde with ethylene glycol Introduction: From the first experiment, the reaction of benzaldehyde and potassium hydroxide will produce two products which are benzyl alcohol and benzoic acid. We are going to look at how to get this two products separated by using their different chemical properties. For the second experiment, benzaldehyde ethylene acetal is formed when the reaction done under acidic environment.…

3.7. Equilibrium isotherms Langmuir isotherm proposed by Langmuir, (1918) with some limitations Dąbrowski, (2001) expressed as: (4) Where qm (mg g–1) is the maximum amount of the metal ion per unit weight of adsorbent, ‘qe’ is equilibrium adsorption capacity (mg g–1), ‘Ce’ is the equilibrium concentration of the adsorbate (mg L–1), and b is a constant which reveals the affinity of binding sites (L mg-1). From the plots between (Ce/qe ) and Ce the slope (1/qm ) and the intercept…

1. INTRODUCTION Thiosemicarbazone is a derivative of imine which is formed when an aldehyde/ketone reacts with a thiosemicarbzide through a condensation reaction. The presence of the hetero atoms like Sulphur and Nitrogen makes these derivatives biologically active. Lately, great emphasis is laid on the synthesis and development of these derivatives reason being the wide variety of pharmacological activities exhibited by them. So far, thiosemicarbazones have been shown to exhibit analgesic and…

B Sridhar et al (2012) studied Purification and Characterization of Biosurfactants. The emulsifications of biosurfactants were checked in various oils such as olive, coconut, sunflower and rice bran oils, the emulsification activity of biosurfactants. Pseudomonas aeruginosa had higher emulsification activity than Saccharomyces cerevisiae. While checking the sugar and lipid content in biosurfactants by phenol sulphuric acid method and vanillin reagent method, found high in Pseudomonas aeruginosa…

Km and Vmax determination of glucocerebrosidase towards p-NPG The Michaelis constant (Km) is a measure of the affinity of the enzyme towards the substrate, with smaller values representing greater affinity. Km and the maximum rate (Vmax) of leukocyte GCase were obtained through the Lineweaver-Burk plot (Figure 4) with artificial substrate p-NPG in concentrations from 0.71 mM to2.50 mM. Km and Vmax values for leukocyte GCase using p-NPG as substrate was found to be 12.6 mM and 333 U/mg…

Lab 14/ Test 6: Determination of Acid Dissociation Constants through Titration Sabrina Tom I.Abstract The two unknown solutions A and E were titrated with NaOH solutions. For each solution, one fast and three slow titrations were done to see where the pH rose exponentially. The unknown solutions A and E were determined to be Pyridinium ion acid and oxalic acid, respectively. II.Theories One significant concept throughout this lab is titrations. A titration is a lab method analyzes a…

1. 6 cleaned and dried conical flasks were collected and safely transported to the experimental table. 2. A black marker was used to mark a black cross on a white sheet of paper. This was to help with measuring the time (dependent variable). 3. A thermometer was placed on the table to measure the room temperature. 4. 0.15mol/L sodium thiosulphate solution (Na2S2O3) and 3mol/L hydrochloric acid (HCL) were poured into two separate 50 ml beakers, and the two beakers were transported to the…